Scribd
Upload
4K views3 pages

LTE Optimization Questions

Ericsson uses the RBS 6000 series hardware for LTE technology. A good RSRP threshold is above -95 dBm for planning and above -113 dBm for radio conditions, and a good RSRQ is below -7dB. Ping latency experienced on LTE networks can range from 40-200ms. Uplink uses SCFDMA and downlink uses OFDMA. There are three transmission modes for LTE - SIMO, transmit diversity, and OLSM, which are configured in moshell. A radio frame is 10ms with 10 subframes.

Uploaded by

roughnot
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
4K views3 pages

LTE Optimization Questions

Ericsson uses the RBS 6000 series hardware for LTE technology. A good RSRP threshold is above -95 dBm for planning and above -113 dBm for radio conditions, and a good RSRQ is below -7dB. Ping latency experienced on LTE networks can range from 40-200ms. Uplink uses SCFDMA and downlink uses OFDMA. There are three transmission modes for LTE - SIMO, transmit diversity, and OLSM, which are configured in moshell. A radio frame is 10ms with 10 subframes.

Uploaded by

roughnot
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

LTE Optimization Questions

1. What RBS Hardware does Ericsson use for LTE Technology? RBS 6000 series 2. What is considered a good RSRP and RSRQ threshold, good for LTE radio conditions RSRP = >-95 dBm (Planning with -113 dBm) RSRQ=<-7dB 3. What latency (RTT) have you experienced while pinging with 32 bytes? 40-200ms 4. What technology is used in the uplink and in the downlink? Uplink: SCFDMA Downlink: OFDMA 5. How many Transmission mode we have? What are they? How they are configured in moshell? Transmission mode: 1. Single Input Multiple Output (SIMO) 2. Transmit Diversity 3. Open Loop Spatial Multiplexing (OLSM) 6. What is the length of one Radio Frame? How many subframes? 1 Radio Frame: 10ms

Subframes: 10 frames 7. Have you used moshell? a. How do you check the alarms Amos Sitename lt all (green font) load MOs Al displays all alarms b. How do you check the site status (if the site is unlocked/locked) trigger to explain the status of the site Load site ST cell (display cell status)

8. What other DT tool or any LTE tool have you ever used? TEMS Discovery & Actix 9. What LTE SW level were you working on? L12A 10. How many Transmission types we have? a. what are they? 1. FDD Frequency division duplex 2. TDD Time division duplex b. What are the subcarrier spacing? 15KHz subcarrier spacing

You might also like