Scribd
Upload
87 views2 pages

Wcdma Events

The document describes various event reporting criteria in WCDMA networks. It includes primary cell signal quality entering or leaving reporting ranges, changes in best cells within active sets, quality thresholds for primary cells and frequencies, timeslot quality changes for TDD mode, compressed mode events, traffic volume thresholds, error rates, UE transmit power, and positioning events. The events are separated into intrafrequency, interfrequency, intersystem, traffic volume, quality, and positioning categories.

Uploaded by

Prasoon Singh
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
87 views2 pages

Wcdma Events

The document describes various event reporting criteria in WCDMA networks. It includes primary cell signal quality entering or leaving reporting ranges, changes in best cells within active sets, quality thresholds for primary cells and frequencies, timeslot quality changes for TDD mode, compressed mode events, traffic volume thresholds, error rates, UE transmit power, and positioning events. The events are separated into intrafrequency, interfrequency, intersystem, traffic volume, quality, and positioning categories.

Uploaded by

Prasoon Singh
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

WCDMA EVENTS

Even ts Description A Primary CPICH enters the reporting range A primary CPICH leaves the reporting range A non-active primary CPICH becomes better than an active primary CPICH Change of best cell in the active set A Primary CPICH becomes better than an absolute threshold A Primary CPICH becomes worse than an absolute threshold A non-active E-DCH but active DCH primary CPICH becomes better than an active E-DCH primary CPICH Change of best cell (TDD) Timeslot ISCP below a certain threshold (TDD) Timeslot ISCP above a certain threshold (TDD) Change of best frequency The estimated quality of the currently used frequency is below a certain threshold and the estimated quality of a non-used frequency is above a certain threshold. The estimated quality of a non-used frequency is above a certain threshold The estimated quality of the currently used frequency is below a certain threshold The estimated quality of a non-used frequency is below a certain threshold The estimated quality of the currently used frequency is above a certain threshold The estimated quality of the currently used UTRAN frequency is below a certain threshold and the estimated quality of the other system is above a certain threshold. The estimated quality of other system is below a certain threshold The estimated quality of other system is above a certain threshold Change of best cell in other system Transport Channel Traffic Volume becomes larger than an absolute threshold Transport Channel Traffic Volume becomes smaller than an absolute threshold A predefined number of bad CRCs is exceeded The UE Tx power becomes larger than an absolute threshold The UE Tx power becomes less than an Enter compressed mode, triggered by high UE power level. Leave compressed mode, Comments Addition a cell into active set. Removal a cell from active set. Replacement of a cell within the active set. Change the best cell.

1a 1b
Intrafreque ncy reporting events for the FDD mode

1c 1d 1e 1f 1j

Intrafreque ncy reporting events for the TDD mode

1g 1h 1i 2a 2b

Used in TDD Mode. Used in TDD Mode. Used in TDD Mode.

Inter-frequency handover.

Interfreque ncy reporting events

2c

2d

Enter compressed mode, start measuring neighbor cells on other frequencies (interfrequency or inter-RAT) triggered by low DL signal.

2e 2f

Leave compressed mode.

3a
Intersyste m reporting events

Inter-RAT handover.

3b 3c 3d

Trafficvolume reporting events Quality reporting events UE internal measurem ent reporting

4a 4b 5a 6a 6b

6c
events

6d 6e 6f 6f 6g

absolute threshold The UE Tx power reaches its minimum value The UE Tx power reaches its maximum value The UE RSSI reaches the UE's dynamic receiver range The UE Rx-Tx time difference for a RL included in the active set becomes larger than an absolute threshold The time difference indicated by TADV becomes larger than an absolute threshold The UE Rx-Tx time difference for a RL included in the active set becomes less than an absolute threshold The UE position changes more than an absolute threshold SFN-SFN measurement changes more than an absolute threshold GPS time and SFN time have drifted apart more than an absolute threshold

triggered by resolution of 6a.

FDD 1.28 Mcps TDD FDD

UE positioning reporting events

7a 7b 7c

You might also like