Quickspecs: Models Models Models Models
Quickspecs: Models Models Models Models
Overview
Models
HP 620 Redundant/External Power Supply J8696A
Product overview
The 620 Redundant/External Power Supply provides redundant system power and/or an extra 398 W of Power over Ethernet (PoE) power for each of two supported switches simultaneously. Ideally suited for Voice over IP (VoIP) environments, the 620 provides the RPS and extra PoE power needed in many other common customer environments where high power availability is desired. Switchover from a failed internal power supply to the 620 is seamless and immediate. In addition, the 620 can protect against a single power main failure by being connected to a different power main than the switch. The 620 supports the HP 3500 Series, as well as 6200 switches.
DA - 12707
Page 1
QuickSpecs
Technical Specifications
HP 620 Redundant/External Power Supply (J8696A) 2 redundant power supply ports Ports Restrictions: 195 W available per port
2 external power supply ports Restrictions: 398 W available per port 15.4(d) x 17.4(w) x 1.73(h) in. (39.12 x 44.2 x 4.39 cm) (1U height) Dimensions 15.2 lb. (6.89 kg) Weight Mounts in an EIA-standard 19 in. telco rack or equipment cabinet (hardware included); horizontal surface mounting only 32F to 131F (0C to 55C) Operating temperature Operating relative 15% to 95% @ 104F (40C), noncondensing humidity -40F to 158F (-40C to 70C) Nonoperating/Storage temperature 15% to 90% @ 149F (65C), noncondensing Nonoperating/Storage relative humidity up to 10,000 ft. (3 km) Altitude LwA per ISO 7779: 54.2 dB Acoustic Maximum heat dissipation 400 BTU/hr (422 kJ/hr), for the actual 620 itself. PoE-powered device heat dissipation assumed to be outside the 620. 100-127/200-240 VAC Voltage 16/8 A Current 1440 W Maximum power rating 390 W RPS power 796 W PoE power 12 V RPS -50 V PoE 50/60 Hz Frequency Maximum power rating and maximum heat dissipation are the worst-case Notes theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. Above figures are for maximum RPS and PoE power being supplied to two switches simultaneously. 200 - 240 V power cords shipped with the 620 have a wall plug rated as close to 13 A as specific country standards allow. CSA 22.2 No. 60950; EN 60950/IEC 60950; UL 60950 FCC Class A; VCCI Class A; EN 55022/CISPR 22 Class A EN 55024, CISPR 24 EN IEC 61000-4-2 ESD IEC 61000-4-3 Radiated IEC 61000-4-4 EFT/Burst IEC 61000-4-5 Surge
Electrical characteristics
DA - 12707
Page 2
QuickSpecs
Technical Specifications
Management Notes
Services
Conducted IEC 61000-4-6 IEC 61000-4-8 Power frequency magnetic field IEC 61000-4-11 Voltage dips and interruptions EN 61000-3-2, IEC 61000-3-2 Harmonics EN 61000-3-3, IEC 61000-3-3 Flicker Unmanaged power supply; provides information via LEDs (LEDs repeated on front and back panel) or through port interfaces of attached devices The 620 supports the HP Switch 2900 Series (RPS) and 3500yl Series (RPS/PoE), as well as 6200yl (RPS) switches. The HP Switch 5400zl Series is not supported. The 620 includes four 2 m RPS/EPS cables. These cables can be used to carry either RPS or PoE power to the switch being powered. 3-year, 4-hour onsite, 13x5 coverage for hardware (U9270E) 3-year, 4-hour onsite, 24x7 coverage for hardware (U9271E) 1-year, post-warranty, 4-hour onsite, 13x5 coverage for hardware (HR840E) 1-year, post-warranty, 4-hour onsite, 24x7 coverage for hardware (HR841E) 4-year, 4-hour onsite, 13x5 coverage for hardware (UR854E) 4-year, 4-hour onsite, 24x7 coverage for hardware (UR855E) 5-year, 4-hour onsite, 13x5 coverage for hardware (UR857E) 5-year, 4-hour onsite, 24x7 coverage for hardware (UR858E) 3 Yr 6 hr Call-to-Repair Onsite (UW371E) 4 Yr 6 hr Call-to-Repair Onsite (UW372E) 5 Yr 6 hr Call-to-Repair Onsite (UW373E) 1-year, 6 hour Call-To-Repair Onsite for hardware (HR842E) Refer to the HP website at: www.hp.com/networking/services for details on the service-level descriptions and product numbers. For details about services and response times in your area, please contact your local HP sales office.
DA - 12707
Page 3
QuickSpecs
Accessories
HP 620 Mounting Kit Redundant/External Power Supply accessories HP X410 1U Universal 4-Post Rack Mounting Kit
J9583A
DA - 12707
Page 4
QuickSpecs
Accessory Product Details
NOTE: Details are not available for all accessories. The following specifications were available at the time of publication. HP X410 1U Universal 4- Notes post Rack Mounting Kit (J9583A) The rack mounting kit supports the 1U, full width switches in the following switch series and the power supply: V1810 Series, E2510 Series, E2520 Series, E2610 Series, E2810 Series, E2910 Series, E3500 Series, and the E620 Power Supply This universal rack mounting kit is design to fit the following racks: HP 10K 10642, HP 10K 10842, Panduit CN, Panduit CS, Wrightline Vantage S2, APC Netshelter 600mm, and APC Netshelter 800mm. It may well fit many other brands and models too. Refer to the HP website at: www.hp.com/networking/services for details on the service-level descriptions and product numbers. For details about services and response times in your area, please contact your local HP sales office.
Services
To learn more, visit: www.hp.com/networking Copyright 2011 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
DA - 12707
Page 5