SBC 5200 Datasheet
SBC 5200 Datasheet
SBC 5200 Datasheet
Designed for communications service providers and large enterprises, the SBC 5200 Session Border Controller is powerful, compact and purposebuilt for the multimedia communications of today and tomorrow. The Sonus SBC 5200 provides all of the features you need in an SBC todayrobust security, sophisticated routing and policy management, overload controls, SIP normalizationplus the features youll need tomorrow, like IPv4-IPv6 interworking, centralized policy management, built-in media transcoding and high performance under heavy traffic. The SBC 5200 Series is available in two form factors: modular (5210) and fixed (5200).
System Capabilities
Routing/Policy
Sessions
based on Codec Up to 32,000 H.323 sessions RTCP sessions scale 1:1 with RTP sessions Call Set-Up Maximum call setup rate: 450 cps Call latency = 30ms (@ 450 cps, 90% fall into this category) Registrations Maximum new registrations/sec: 1000 Maximum refreshes/sec: 5000 Total registered end point support: 256,000; up to 64,000 NAT'd end points Encryption Maximum number of TLS sessions: 256,000 TLS set-up rate: 150/sec Maximum # of IPsec tunnels: 2048 (4096 IPSec SAs) IPsec (IKE) setup rate: 120/sec Maximum # SRTP sessions: 64,000
Redundancy
Management Capabilities
PSX Policy/Route Server using DIAMETER+ Screening, blocking, routing, presentation, call type filters Route prioritization Leading digit routing; International routing; URI based routing Digit/parameter manipulation E911 support; Priority Call handling
configuration Secure embedded web-based management GUI Sonus CLI, SSH Centralized support by Sonus Insight EMS SNMP V2 status and statistics Local logging of events, alarms, and traps; Call trace Sonus DSI Level 0 support for storing CDRs; RADIUS accounting records Live Software Update (LSWU)
Security
Session aware firewall; Topology Line rate DoS/ DDoS, and Rogue RTP Line rate malformed packet TLS, IPSec (IKEV1) for signaling Secure RTP/RTCP for media
encryption encryption protection protection Hiding
Media Services
Signaling
G.723, iLBC, G.722, AMR-NB, AMR-WB, EVRCB0 Wireline, wireless, wideband and clearchannel codec pass through T.38 compliant fax relay or fall back to G.711 VAD, Silence Suppression, Dynamic Jitter Buffer, Fax/ Modem Detection, DTMF/Tone Relay/RFC2833/RFC4733 interworking NAT/NAPT on media DTMF Trigger Detection and Notification Generic audio codec relay Tones & Announcements
Back to Back User Agent (B2BUA) SIP, SIP-I/SIP-T, SIP/H.323; Sonus Gateway to Gateway Signaling SIP protocol normalization/ protocol repair; SIP message manipulation NAT/NAPT on signaling
Protocol Support
Bandwidth management Call admission control (CAC) per Per call statistics TOS/ COS packet marking
Packet Network Time Source
trunk group, per zone
IPV4, IPV6, IPV4/IPV6 interworking SSH; sFTP SNMP; NETCONF; NTP HTTP/HTTPS RTP/RTCP UDP, TCP DNS, ENUM
1
Hardware Specifications
Front Panel
Chassis
Operating Altitude:
2U, rack mount Inches: 17.5" Wide x 3.5" High x Centimeters: 44.5 Wide x 8.8 High x
53.3 Deep Optional mounting brackets for 19" or 23" rack 21" Deep
Rear Panel
Management Ports:
SBC 5200: 50 lbs. (22.68 kg) SBC 5210: 50 lbs. (22.68 kg)
Environmental:
10/100/1000 Ethernet RJ-45 ports Media Ports: Four 1 Gbps Ethernet fiber or copper via SFP High Availability Ports: Two 1 Gbps Ethernet multimode fiber via SFP Single Field Service port with RJ45 connector Locator LED Alarm port with DB15 connector Single serial craft DB9 port
AC Power Option: RMS Input Voltage Minimum 90 VAC Nominal 100-240 VAC Maximum 264 VAC
RMS Current
5.6A
Regulatory Compliance
Central Office Standards:
Input Frequency
Memory
DC Power Option:
24 Gbytes
DSP Expansion
Model 5210: Modular DSP slots Model 5200: Fixed DSP cards
Table 1. Estimated Power Consumption (all power measurements taken with fans running high)
Configuration
SBC 5200 Peak Consumption: 18.8A SBC 5210 Peak Consumption: 17.3 A
DC Input (W)
Minimum: 40 Vdc Nominal: 48 Vdc Maximum: 60 Vdc
Amps Watts
SBC 5210 - No DSP Cards SBC 5210 +1 DSP25 SBC 5210 +2 DSP25 SBC 5210 +3 DSP25 SBC 5210 +4 DSP25
AC Low Line
Minimum: 90 Vrms Nominal: 100-120 Vrms Maximum: 140 Vrms
SPS100 SPS100DB Amps Watts
AC High Line
Minimum: 180 Vrms Nominal: 200-240 Vrms Maximum: 264 Vrms
Amps Watts
DC
Minimum: 40 Vdc Nominal: 48 Vdc Maximum: 60 Vdc
Amps Watts
0
SBC 5200
0 0 1 2
1 1 1
DS-1301 05/08 3