8 7 6 5 4 3 2 1

DATUM ALIGNMENT HOLE

SLIDE ASSEMBLY NOTES: MUST BE AT BOTTOM OF SLIDE
1. FIRST STEP IS TO ASSEMBLE THE DRIVE NUTS TO THE TOP PLATE, BUT LEAVE SOME PLAY AND BOTH TO LEFT OR RIGHT
2. NEXT ASSEMBLE END PLATE TO LINEAR RAIL, THEN LINEAR BEARINGS ONTO RAILS SIDE
3. THEN PUT FINAL END PLATE ON LINEAR AXIS, TAP INTO PLACE WITH PLASTIC HAMMER
4. SCREW LINEAR BEARINGS ONTO TOP PLATE
D
D 5. ALIGN TOP PLATE TO END PLATES AND TIGHTEN DOWN LINEAR BEARINGS
6. IMPORTANT STEP, STRIKE TOP OF PLATE WITH PLASTIC HAMMER TO SET LINEAR BEARINGS
7. DO THIS UNTIL SLIDE MOVES SMOOTHLY, SOME FRICTION IS OK BUT NO SLOP
8. ASSEMBLE MOTOR MOUNT COMPONENTS.

C C

B B

UNLESS OTHERWISE SPECIFIED: NAME DATE

DIMENSIONS ARE IN INCHES DRAWN

TOLERANCES:
FRACTIONAL CHECKED TITLE:
A ANGULAR: MACH BEND
ENG APPR. A
TWO PLACE DECIMAL
THREE PLACE DECIMAL MFG APPR.

BOTTOM ISO VIEW OF LINEAR SLIDE

INTERPRET GEOMETRIC Q.A.
PROPRIETARY AND CONFIDENTIAL TOLERANCING PER:
COMMENTS:

SHOWN FOR COMPONENT CLARITY

THE INFORMATION CONTAINED IN THIS MATERIAL
SIZE DWG. NO. REV

B Linear Slide
DRAWING IS THE SOLE PROPERTY OF
<INSERT COMPANY NAME HERE>. ANY
REPRODUCTION IN PART OR AS A WHOLE FINISH
WITHOUT THE WRITTEN PERMISSION OF NEXT ASSY USED ON
<INSERT COMPANY NAME HERE> IS
PROHIBITED. APPLICATION DO NOT SCALE DRAWING SCALE: 1:1 WEIGHT: SHEET 1 OF 2
8 7 6 5 4 3 2 1
 8 7 6 5 4 3 2 1

DRIVE STATIC
NEMA-23 #10-32 x 1/2 END LINEAR LINEAR END
MOTOR FILLISTER SCREW PLATE RAIL TOP PLATE DUAL BEARING PLATE
DRIVE
NUTS D
D

THREADED
STANDOFF

C C

#10-32 x 2"
B
ROUND HD SCREW B

THRU HOLE
STANDOFF

1/4-20 .250" ID
1/4-20 NUT LEAD SCREW FLANGED
BALL BEARING
1/4" ID
COLLAR
UNLESS OTHERWISE SPECIFIED: NAME DATE

DIMENSIONS ARE IN INCHES DRAWN

TOLERANCES:
FRACTIONAL CHECKED TITLE:
A ANGULAR: MACH BEND
ENG APPR. A
TWO PLACE DECIMAL
THREE PLACE DECIMAL MFG APPR.

INTERPRET GEOMETRIC Q.A.

BOTTOM VIEW OF LINEAR SLIDE

PROPRIETARY AND CONFIDENTIAL TOLERANCING PER:
COMMENTS:
THE INFORMATION CONTAINED IN THIS MATERIAL
SIZE DWG. NO. REV

B Linear Slide
DRAWING IS THE SOLE PROPERTY OF
<INSERT COMPANY NAME HERE>. ANY
REPRODUCTION IN PART OR AS A WHOLE FINISH
WITHOUT THE WRITTEN PERMISSION OF NEXT ASSY USED ON
<INSERT COMPANY NAME HERE> IS
PROHIBITED. APPLICATION DO NOT SCALE DRAWING SCALE: 1:1 WEIGHT: SHEET 2 OF 2
8 7 6 5 4 3 2 1