Bump Steer
Bump Steer
Bump Steer
Definition: The tendency of a vehicle to suddenly veer or swerve to one side when hitting a bump or dip in the road. The condition is caused by uneven toe changes that occur as a result of the steering linkage or rack not being parallel with the road surface. This causes the wheels to change toe unevenly as the suspension undergoes jounce and rebound. Jump
to: navigation, search Bump steer or roll steer is the term for the tendency of the wheel of a car to steer as it moves upwards. It is typically measured in degrees of steer per metre of upwards motion or degrees per foot. On modern cars the front of the tire moves outwards as the suspension is raised, a process known as the front wheels "toeing out". This gives roll understeer. The rear suspension is usually set up to minimise bump steer, where possible. Typical values are from two to ten degrees per metre, for the front wheels. Excessive bump steer increases tire wear and makes the vehicle more difficult to handle on rough roads. Solid axles generally have zero bump steer, but still have roll steer, in most cases. That is, if the wheels move upwards by the same amount, they tend not to steer.
Death Wobble is different from bump steer in that it is unwanted vibration of the steering, not a simple single event bump. The vibration amplitude increase during DW becomes so large that it feels like the steering wheel will be ripped out of your hands. The tires and steering linkages rotate, bend, and flex at a frequency that is not dampened but increases. A change in speed will usually reduce the DW (normally easy) but sometimes the reaction is so severe that the vehicle chooses it's own path before you can slow down. There are many factors impacting DW and most near stock vehicles suffer DW due to worn components. Play in the components will allow small movement of the steering and axle increase until the vibration matches the road speed (usually near 40 to 55 mph), and then increase in amplitude with the energy of a quick bump. Lifted vehicles have the acute steering angle to compound the problem along with greater tire weight to store more energy. This is the aspect of DW that most people overlook, the storage and release of energy during the DW vibration. When the energy stored exceeds the friction dampening of the loose steering component the released energy impacts the steering wheel (you feel it wobble). The factory uses a stabilizer to dampen and reduce the vibration energy (convert it into heat). Again, the lifted vehicle usually results in a steep steering stabilizer mount angle that reduces the effect of the stabilizer damper. Keeping the stabilizer level (in-line with the DW vibration) will help a DW problem. This is not the fix if other components are loose, but a solution aid if the components are good. Another element is the stiffness of the tie rods and drag link. Heavier parts that provide more resistance to vibration bending help reduce the DW. A major contributor to stored energy is tire weight and tire offset from the spindle bearing centerline. Greater offset (less rim backspacing) places the tire energy on a longer moment (lever) arm that quickly amplifies the tire energy on the steering. A smaller tire with a rim using less backspacing (30's on a 3.75 BS rim) will impart greater energy than a larger tire with less offset (33 on 5.25 BS rims) masking the impact of mere tire weight and size. Keep the rim BS close to stock and the potential for DW is reduced. Reducing the caster and toe to zero also reduces the dynamic energy imposed by the tires rolling on different paths, resulting in alignment as a major contributor to DW. The bending that occurs at the knuckle (or in the wheel bearing) is unavoidable unless the weak area is reinforced. Another poster's concern regarding the wheel bearing is valid because little can be done to change the strength without changing the design (but what if the real problem is a weak knuckle/spindle). This post provides considerable information to chew on, with a few recommendations, so I'll stop. Be aware that straight axle Fords, Toyota's, and Dodges all suffer from some DW so you can run away but not hide from the problem.