Scribd
Upload
100 views2 pages

Plc1-D Ac Contactor

This document provides specifications for PLC1-D AC contactors, including: 1. It lists the rated insulation voltage, rated impulse withstand voltage, applicable standards, and degree of protection for different contactor types from D09 to D150. 2. It specifies the permissible tightening torques and connection cross section sizes for flexible and solid cables connected to the contactors via screw clamps, spring terminals, or bars/lugs. 3. It gives the operating temperature ranges and maximum operating altitudes for the contactors.

Uploaded by

Nguyen Van Chung
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
100 views2 pages

Plc1-D Ac Contactor

This document provides specifications for PLC1-D AC contactors, including: 1. It lists the rated insulation voltage, rated impulse withstand voltage, applicable standards, and degree of protection for different contactor types from D09 to D150. 2. It specifies the permissible tightening torques and connection cross section sizes for flexible and solid cables connected to the contactors via screw clamps, spring terminals, or bars/lugs. 3. It gives the operating temperature ranges and maximum operating altitudes for the contactors.

Uploaded by

Nguyen Van Chung
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

PLC1-D AC CONTACTOR

AC CONTACTOR
SPECIFICATIONS

Type of contactor

PLC1-

D09...D18

D25...D38

D40

D50...D95 D115...D150

Conforming to IEC 947-4-1, Rated insulation voltage overvoltage category , (Ui) degree for pollution: 3

690V

690V

1000V

1000V

1000V

Rated impulse withstand Conforming to IEC 947 voltage (Uimp) PLC1-D 09/12/18 Conforming to standards Power connection Degree of protection (1) (front face only) protective treatment Coil connection Conforming to IEC 68 Storage

6KV

6KV

8KV

8KV

8KV

IEC 60947-1, 60947-4-1, EN 60947-1, EN 60947-4-1 Protection against direct finger contact IP 2X Protection against direct finger contact IP 2X (except CKYC1-D40...D80) TH -60...+80 -5...+60 -40...+70 ,for operation at Uc

Ambient air temperature Operation around the device Permissible

Maximum operating Without derating altitude Operating position Flame resistance Shock resistance (2) PLC1-D 25/32 1 / 2 sine wave = 11ms Vibration resistance (2) 5...300 Hz Without derating 30o possible, in relation to normal vertical mounting plane 3000m

Conforming to IEC 695-2-1 960 Contactor open Contactor closed Contactor open Contactor closed 10 gn 15 gn 2 gn 4 gn 8 gn 15 gn 2 gn 4 gn 8 gn 10 gn 2 gn 4 gn 8 gn 10 gn 2 gn 3 gn 6 gn 15 gn 2 gn 4 gn

(1) Protection ensured for the connection cross-sections shown on the next page and for connection via cable. (2) In the least favourable direction, without change of contact state (coil supplied at Ue)

B A-01

PLC1-D AC CONTACTOR
AC CONTACTOR

SPECIFICATIONS
Type of contactor PC1D09 & D12 D18 DT20 & (3P) T25

D25 D23 D38 D40

D50 & D80 & D65 D95

D115 & D150


2-input connector 10...120 10...120+10...50 10...120 10...120+10...50 10...120 10...120+10...50 -

Tightening
Flexible cable 1 conductor

Screw clamps mm 2 mm 2 mm 2 mm 2 mm mm
2

Screw clamps

1-input connector

1...4 1...4 1...4 1...2.5 1...4 1...4 N 2 6 o

1.5...6 1.5...10 2.5...10 2.5...25 2.5...25 4...50 1.5...6 1.5...6 1...6 1...4 1...6 1...4 2.5...10 2.5...16 2.5...16 4...25 1...10 2.5...25 2.5...25 4...50

Without cable end 2 conductors Flexible cable With cable end 1 conductor 2 conductors 1conductor

1.5...6 2.5...10 2.5...10 4...16 1.5...10 2.5...25 2.5...25 4...50 1.5...10 2.5...16 2.5...16 4...25 No 2 6 2.5 5 -

PLC1-D 40/50/65

Solid cable

1.5...6 1.5...6 1.5...6 1.5...6 No 2 No 2 6 1.7 2.5 6

Without cable end 2 conductors Screwdriver Head flat screw/driver 6 sided key Tightening torque

6... 8 6... 8 6... 8 5 4 9 4 12

N.m

1.7

CONNECTION VIA SPRING TERMINALS (2)


Flexibl cable 1 conductor without cable end 2 conductors mm 2 mm 2 2.5 (4: DT25) 4 4 4 -

2.5(except 4 DT25: -)

CONNECTION VIA BARS OR LUGS


PLC1-D 80/95 Bar cross-section Lug external of screw Screw/driver Head flat screwdriver Key for hexagonal headed screw Tightening torque N.m 1.7 mm mm 8 8 10 10 13 M5 16 3x16 17 5x25 25 M8 8 10 9 13 12

M3.5 M3.5 M4 M4 N2 6 1.7


o

M6 M6

No2 6

No2 No2 6 6

No2 No2 6 5 5 8

2.5 2.5

B A-02

You might also like