Prospects of Tidal Power in Bangladesh

Introduction: Tidal power is not a new concept and has been used in Britain and France since at least the 11th century for milling grains (ACRE, 1999). Oceans cover over 70% of the earth's surface and the energy contained in waves and tidal movements is enormous. It has been estimated that if less than 0.1% of the renewable energy available within the oceans could be converted into electricity it would satisfy the present world demand for energy more than five times over (Wavegen, 1999). However, tidal power remains well below its potential in terms of application. Presently, tidal plants exist only in France since 1967 (La Rance), Canada since 1984 (Annapolis Royal), and in China (the Bay of Kislaya and Jiangxia Creek). Many tidal projects are being considered today including the seven projects in England, Derby Hydro Power of Western Australia: (48 MW); Corova, south coast of Alaska; Southern portion of Chile; Gujarat, India: (1000 MW); Mexico: (500 MW); the Philippines: (2200 MW) and China: (20,000 MW) (Tidal Electric Inc, 1999; Green Energy, 1999; ACRE, 1999). The usual technique in harnessing the tide is to dam a tidally-affected estuary or inlet, allowing the incoming tide to enter the inlet unimpeded and then using the impounded water to generate power. The main barriers to uptake of the technology are environmental concerns and high capital costs. In recent years, these problems have been mitigated considerably by design, by involvement of experts and local communities in the identification and installation of new plant, and by a growing understanding of how to achieve more sustainable energy development. However there have been very few studies in the academic literature that analyze this process of how a new form of sustainable energy has been changing to become more mainstream and acceptable (Baker, 1991). Generally speaking, it is quite possible to harness energy from the tides; however the technology is not yet practically and commercially available; there are also environmental concerns. Therefore, until now, tidal power generating issues have not been substantively addressed. The attempts to achieve environmental resolution will be the primary focus. The other major problem of high capital costs. Like hydro schemes, tidal power has high capital costs due to the large scale of engineering involved, but involves low operating costs. Tidal power has the extra problem of having to be located in a coastal environment where engineering is likely to be even more costly due to the changeability of the coast. However, there is no research that has been conducted yet where the coastal engineering infrastructure is already present (like Bangladesh Coastal Islands). Tides and Tidal Power: The gravitational forces of the sun and the moon on the rotating earth causes the oceans water to bulge upwards, resulting in tides with two high tides occurring every 24 hours and 50 minutes;

every rise and fall stores a large amount of potential energy. The energy of the tides comes from the rotational energy of the earth (Derby Hydro, 1999). Tidal energy is generated from the power of the changing tides, called tidal range (the difference between height of high tide and low tide point). This tidal change in sea level can be used to generate electricity by building a dam across a coastal bay or estuary with large differences between low and high tides. The high tides allow immense amounts of water to rush into the bay. The gates (sluice gate) of the dam are then shut when water level is at its maximum height. Outlets in the bottom of the dam allow water (at great speed and pressure) to rush past the turbines. The flow of water generates enough power to turn the turbines which, in turn, creates electricity. The generation of electricity from tides is very similar to hydroelectricity generation, except that water is able to flow in both directions and electricity is created utilizing two-way turbines. The tidal range varies throughout the lunar month according to changes in relative positions of the sun, the earth and the moon. When the sun, the earth and the moon line up (twice monthly), the two daily high tides are extra high and give the largest tidal ranges of the month, called Spring Tidal Range (ACRE, 1999). Tidal power stations can be stretched over deltas, estuaries, beaches, or other places that are affected by the tides. Tidal Power Prospects in Coastal Bangladesh: Bangladesh is a country with low use of electricity (per capita consumption of 95 Kw.hr) and considerable need for development along its coastal area. Current electrification is estimated at only 16% of the population, with rural access of less than 5% (BCAS, 1998). This places Bangladesh's electrification rates amongst the lowest in the world. Bangladesh has a long coastal area (710 km) with 2~8 m tidal height/head rise and fall (table-1, BIWTA, 1999). It also has some large tidal sites and many channels of low tidal range in a large number of deltaic islands, where barrages and sluice gates already exist. Therefore, the potential for tidal power to be harnessed is significant, because the barrages necessary for creating controlled flow through turbines (to tap tidal power) are also needed for flood control. This avoids the problem of high capital cost as the engineering is either already there or is needed for cyclone protection. Analysis of the following two tables indicate that Bangladesh has very good prospects for tidal energy, particularly in Sandwip. The island of Sandwip is located in the Bay of Bengal, adjacent to Chittagong and is a mere 15 km from the mainland. The population is around 330,000 on an area of 240 km2. The entire island is a mudflat created from the Ganges delta. A scoping visit to Sandwip was made in late November, 1999 by the Executive Agencies (Institute for Sustainability and Technology Policy (ISTP), International Centre for Application of Solar Energy (ICASE) and Tidal Energy Australia (TEA) assisted by the Rural Electrification Board and Grameen Shakti of Bangladesh. A photo voltaic (PV) system is used to maintain a fridge for vaccines in the health centre. The mud flats are composed of extremely rich soil, hence it is easy to grow a variety of food crops. The island is an exporter of rice and is largely self sufficient in vegetables and fruits. No aquaculture is conducted on the island, though shrimps are collected

from the mud flats. None of the island's schools or colleges have electricity and opportunities for employment growth on the island are limited. This island is not a tourist haven and is also rarely visited by Bangladeshi's. The 5 m tides experienced at Sandwip results in poor accessibility, with the island constantly surrounded by mud flats, except during high tides. The island is subject to flooding from cyclones and in 1991 over one thousand people were drowned. A flood control barrage exists around the entire island and contains 28 sluice gates. A short electricity grid is also available linking the main commercial areas on the island. Two diesel generators of 200 KW run for a few hours late afternoon/early evening supplying electricity, mainly for commercial use. Some households have batteries and some diesel generators are used for powering rice threshers. According to the scoping visit and expert analysis of different tidal range, Bangladesh may harness energy from coastal tidal resources by applying two technologies: 1. Low head tidal movements (2~5 m head); and 2. Medium head tidal movements (> 5 m head).
Table -- 1; Tidal levels in Coastal Bangladesh (BIWTA, 1999).

Explanation: MLWS = Mean Low Water Spring, MHWS = Mean High Water Spring, MHWN = Mean High Water Neap, MLWN = Mean Low Water Neap, ML = Mean Level, AT = Astronomical Tide, LAT = Lowest Astronomical Tide, HAT = Highest Astronomical Tide, TR = Difference between lowest and highest tidal height in m.

A. Low Head Tidal Movements: Coastal Bangladesh, particularly Khulna, Barisal, Bagerhat, Satkhira and Coxs Bazar regions are, geographysically, extensively deltaic with levees and sluice gates. These areas are protected by embankments, which had been constructed during 1960s for protection from natural disasters like flooding and tidal surges. Therefore, the infrastructure needed for barrages and sluice gates is already present in this regions. These barrages and sluice gates may be used for electricity generation by applying simple technology. The proposal has three elements. Firstly, the use of an undershot paddlewheel with simple civil construction enabling the placement of the wheel at appropriate locations in the levees/barrages. The existing technology of undershot paddlewheels is historical, and generally uses a greater

head as the energy source. Paddlewheels are generally not as efficient at harnessing the energy from moving water as are turbines or revolving blades using the lift principle; however the proposed application is seen as appropriate. The second element is the use of recently developed, variable speed, electricity generation equipment. This is attached either directly to the wheel or via a simple gearing-up mechanism. The third element is the use of existing electronic controllers, appropriate for small-scale machines, to regulate the power output from variable water flow. Suitability: The proposal is appropriate given the relatively low cost of individual generation stations. The civil construction is small-scale and the manufacture of the paddlewheel is envisioned to be carried out locally. The technology is currently available, although adaptations may be required. Further Research and Development: Work needs to be done on civil design to maximize the very low head differences. Current flume knowledge may be a suitable starting point. Paddlewheel design needs development, once again, because of the very low head differences, though a wealth of historical knowledge exits. Work is also required to relate paddlewheel outputs with electricity generators and the controller. The scale of electrical output then has to be matched against potential demand. B. Medium head tidal movement: The most favorable locations for tidal power application of this type are on the eastern side of the delta region, such as Sandwip. The height tidal ranges occur at the following tidal measurement stations: BIWTA Gauge No 32 : Satalkhal - Sandwip Mean Spring Range = 6.01 M MPA Gauge No 2 : Khal No 10 Mean Spring Range = 4.81 M BIWTA Gauge No 31 : Sadarghat Mean Spring Range = 4.72 M The kind of engineering required given increasing sea levels (due to greenhouse warming) can, under this scenario, be adapted for use as a renewable technology for the future. The environmental issues in the area need to be assessed but the coast is already heavily engineered for control of flooding and also for fish farming and rice cultivation. It is hoped that the project will provide an integrated approach to island development where the tidal power outcome is part of a bigger concept involving aquaculture and water management. This is a powerful motivation for developing tidal power as it promises sustainable energy for Bangladesh. Box-1 explains how tidal power of Sandwip could be produced for sustainable coastal development in an isolated remote island in Bangladesh. Potential for Utilization of Energy in Coastal Bangladesh The coastal environment is an area where terrestrial and marine environments interact to form unique environmental conditions including inshore waters, intertidal areas and extensive tracts of land. Although the coastal environment is an interface between land and sea, the area of real concern is that region where human activities are interlinked with both land and marine environments. This area has been defined as the coastal resource system. This resource system can be used in a sustainable way, if the supply of electricity can be ensured. There is great potential to set up

industries and other income generating activities in the coastal region if electricity, can be assured. For example, shrimp farming in the coastal areas of Bangladesh has expanded extensively with the increasing demand from the international market. There is a rapid increase in land use for shrimp farming; in 1983~84 about 40,835 ha, 1985~86 about 68,000 ha and 1990 about 96,048 ha land. The total number of brackish water shrimp farms in 1992~93 was 6540 with an average pond area of 16.5 ha and total land area in 1994 under cultivation of Peneaus monodon was 1,35,000 ha. as shrimp ponds, locally called Gher. With the availability of electricity, it will also improve tourism, prevent green house gas emissions (clean development mechanisms, CDM) and develop an integrated plans for coastal zone management such as integration of modern aquaculture, livestocks, water resource and agriculture management with community development. Conclusion: Considering all the above situations, Bangladesh may proceed to establish tidal energy based turbine to generate electricity using tidal stream system where kinetic energy of high and low tides are moving water. The Norman and Sandwip channels would be the ideal place to place these turbines. In later time, it may search new places and in this age oof satellites, it is easy to identify deeper channels. References: 1. ACRE (1999), Tidal Power Systems; http://acre.murdoch.edu.au/refiles/tidal/text.html Australian CRC for Renewable Energy, Alternative Energy Development Board. 2. Baker, AC (1991), Tidal Power. London, Peter Peregrinu on behalf of the Institutions of Electrical Engineers. 3. BIWTA (1999), Bangladesh Tide Tables, Department of Hydrography, Bangladesh Inland Water Transport Authority of Dhaka, Bangladesh.