4d

s a
tu

es

s3

MAIN FEATURES
1 . 192DMX Channels. 2. 30 Banks each composed of 8 programmable scencs. 3.8 fades adjusting output level. 4.Built -in Microphone. 5. AUTO mode is controllcd by TAP SYNC and SPEED controlled. 6.MIDI control through MIDI interface. 7.4 digits LED display. 8.Fird digit of LED shows CHASES , the second digit of LED shows scenes. 9.Third and fourth digit oCLED shows BANKS. lO.The second^ third> burth digit of I ,KD show stcps or 0-255 or TIME. ll.Blackout master controlled by M annual or R ornte. 12. CHASE programming and CHASE runnyng, manual control and renote control. 13.Fade Time control 14.DMX polarity selects.

TECHNICAL SPECUTCATION
Power Input: DC+9-12V Output: AC230V~50Hz (AC120V60Hz)300Ma ,DC9V300Ma. Dimensions: 482 X 132X73mm Weight: 2.5Kg

OPERATmG INSTRUCTIONS
GENERAL DESCRIPTIONS: I . There is 192 DMX channel adjusting output level in every scene. II . 8scenes are available to be programmed for each bank. When scene running, all scenes of one bank will be executed continuously in a cycle. III. Select desirde bank using UP and DOWN button, Also you can select

desired bank using MIDI signis through MIDI interface ,there are totally 30 banks, once only one can be chose. IV .Scenes can be executed automatically ,and the duration is dependent on TAP SYNC ,scenes are executed under music or NOTE triggering ,also press a scene buttons by hand to run scenes. V .There are total 6 chases, each contains240 scenes. You can choose CHASES. Running one or more ,and MIDI signal remote controlling. 2 .CONTROLS & FUNCRIONS 1. seanners (1-12) LED Fade control Channel Seanners OFF OFF 1-16 1 OFF OFF 17-32 2 OFF OFF 33-48 3 OFF OFF 49-64 4 OFF OFF 65-80 5 OFF OFF 81-96 6 OFF OFF 7 97-112 OFF 113-128 OFF 8 OFF OFF 9 129-144 OFF 145-160 OFF 10 OFF OFF 161-176 11 OFF OFF 12 177-192 Seanners 1 2 3 4 5 Channel 1-16 17-32 33-48 49-64 65-80 Fade control ON ON ON ON ON LED ON ON ON ON ON

ON ON ON ON ON ON ON Press desired scanner, corresponding LED is lit ,and appropriate channels is enabled to be adjusted, when scenes are running ,if fades control is OFF , channel output level is not controlled by the fades ,if fades if fades control is ON, channel 8-output leve is controlled by the fades. 2. scene button Press one scene button to run scene or to store, and the second digit of LCD DISPLAY showsscenes 1-8. 3.fade(l-8) Slide the fades to adjust the output level of DMX channel from 0 to FF.(255) 4.PAGE SELECT Press to select page A to B 1. SPEEDSLIDER Move the slider to adjust chasing speed. 2. FADE TIME SLIDER Move the slider to adjust FADE TIME. 3. LED DISPLAY 4. BAND button ( t or \ ) Press UP or DOWN to increase or decrease Bank, the third and fourth digit of LED DISPLAY shows BAND NO.(01-30) 5. CHASE 1-CHASE 6 Select ddsired CHASE to be programmed or run CHASE. 6. PROGRAM

6 7 8 9 10 11 12

81-96 97-112 113-128 129-144 145-160 161-176 177-192

ON ON ON ON ON ON ON

T urn the power on ,it is in MANUAL RUN mode, press PROGRAM for 2 seeonds, corresponding LED blinks, SCENE and CHASE are ready to be brogrammed, press PROGRAM once more to return to RUN mode, corresponding LED goes out. 7. MIDI/ADD A > Press MIDI key when running ,the third and fourth digit of LED flash, select MIDI channel using UP or DOWN, press MIDI key to make programe when in PROGRAM mode. B> Press this key to make programe when in PROGRAM mode. 8. AUTO/DEL A > In RUN mode, press Auto/Del, corresponding LED is ON ,which indicates it is AUTO RUN mode, press once more to withdraw MUSIC mode, corresponding. LED goes out. B , Press this key to make S cene and chase program when in PROGRAM mode. 9. TAPSYNC/DISPLAY A> In AUTO RUN mode, running speed of scene is interval of last TWO pressing of TAP SYNC/DISPLAY ,Max.lO minutes. B , In PROGRAM mode, select display between STEP and BANK ,in other mode: Select display between 00-225 and 0%-100%. 10. BLACKOUT Press this key to disable all channel output, but not any other functions .Press once withdraw Black out mode. 11. MIDI IN Use to receive MIDI data. 12.DMX POLARITY SELECT Select the polarity of DMX output. 13. DMX OUT Use to output DMX 512 signal 14. DCINPUT DC9V-12V ,300 Ma ,MIN.

PROGRAMMING FOR SCENES

Press PROGRAM for 3 second, appropriate LED blink ,which indicates it in PROGRAM mode . 1. SECNE PTOGRAMMING I .Press SCANNER key to select DMX channel composed. Of 8 channels. II .Select different channel to conrtol several devices at the same time. III.A djust appropriate fades to select desired output level ,then turn off fade. IV.Selcet and adjust outpul level conlinuously until all devices are set. V.Press MIDI/ADD. 2. SCANNER COPY I . Select desired scene of bank. II .Make program of scene of scene to meetthe requirement of device. III. Press MIDI/ADD ,add a programmed scenes. 3. SCENE EDITING Add a STEP in CHASE .Select desired LCD display Presses TAP SYNC/DISPLAY ,the LCD shows the CHASE and its STEP, If it has made program till the 15th step ,select the 9th using UP or DOWN, Press MIDI/ADD, the CHASE is maintained and the STKP tums to lOth STEP. Seleet desired SCENE using UP or DOWN ,Press MIDI/REC ,then the new lOth STEP is added to SCENE, the previous lOth STEP turns to the new llth STEP, the previous llth STEP turns to the new 12th STEP, and so on. Delete a STEP in CHASE Select desired STEP and then press AUTO /DEL. For example, select the lOth STEP using UP or DOW, press ATUO/DEL ,then lOth STEP is deleted, the previous 1 llh STEP tums to the lOth STEP, the previous 12th STEP, and so on. 4. DELETE A CHASE

1:

I .Select desired CHASE II .Press desired CHASE while holding Auto/DEL. 5. CLEAN ALL CHASE (ALL SCENES are stil availanble) I .Press DOWN +Auto /DEL while tuming power off. II .Turn the power on.

RUNNING SCENES
Turn the power on it is in MANUAL RUN mode. when in PROGRAM mode ,press PROGRAM for 2 seconel PROGRAM LED goes out ,it enters MANUAL mode. If there is not any scenes having been brogrammed in a bank, the scene cant be run, only the SCENES having been brogrammed are executed. If the fades is set to OFF , Scene will execute channel program setting. 1. MANUAL URN I .Extinguish AUTO Triggered LED and MUSIC triggered LED. II .Select a bank (using t or I ,MIDI signis through MIDI interface). Ill.Press scene to run scene. IV .Press the SCANNER to copy to,then the SCANNER is copied to anther SCANNER. 2. AUTO RUN I .Press AUTO/DEL,corresponding, LED is ON. II .Press TAP SYNC/DISPLA,Press it onee more aer some time ,the interval between two bressing is assigned to the speed of AUTO RUN ,the mximum limit is 10 minutes .If there are many pressings more than twice ,the last two pressing are designated. III.Select desired bank, using UP or DOWN via MIDI signis. IV.Press Auto/DEL once more to withdraw AUTO RUN mode. 3.MUSIC RUN

I .Press music/Bank copy, corresponding indicator lights ,scene run is engaged into MUSIC RUN. II .Select desired bank, rsing UP or DOWN or via MIDI signis. Ill.Press music /bank copy once more to withdraw MUSIC RUN. 4.MIDIRUN Select bank to run scenes using MIDI whenever it is in MANUAL RUN ,AUTO RUN or MUSIC RUN. 5.CHASERUN I .CHASE RUN requires making prograns, when raning CHASE, scene will be step auto matching. II .CHASE RUN includes MANUAL RUN,AUTO RUN ,ATDIO RUNS, and MIDI RUN. III.Eigher one CHASE more can be run in the order of selection . IV.Press CHASE, Corresponding indicator lights, which indicates it, is in CHASE RUN. 6.FADE TIME CONTROL Move the slider to adjust FADE, Output varies accordingly.

MIDI CHANNEL SETTING

1. MIDI channel setting I .Press MIDI ,the third and fourgh digits of LED blink, selects MIDI channel setting. II .Press MIDI one more to end MIDI channel setting. Also you can press any other key except UP and DOWN or move the fades to end MIDI channel setting. 2. MIDI RUNNING NOTE ON: Receive NOTE ON signis to execute corresponding function.

BANK

BANK 1

BANK2

NOTE NUMBER 00 01 02 03 04 05 06 07 08 09 10

FUNCTION TURN ON TURN OFF CENE1 TURN ON TURN OFF ENE2 TURN ON TURN OFF SCENE3 TURN ON TURN OFF SCENE 4 TURN ON TURN OFF SCENE5 TURN ON TURN OFF SCENE6 TURN ON TURN OFF SCENE7 TURN ON TURN OFF SCENE8 TURN ON TURN OFF SCENE1 TURN ON TURN OFF SCENE2 TURN ON TURN OFF SCENE3

BANK15

CHASE

112 113 114 115 116 117 118 119 120 121 122 123 124 125 126

TURN ON TURN OFF SCENE1 TURN ON TURN OFF SCENE2 TURN ON TURN OFF SCENE3 TURN ON TURN OFF SCENE4 TURN ON TURN OFF SCENE5 TURN ON TURN OFF SCENE6 TURN ON TURN OFF SCENE7 TURN ON TURN OFF SCENE8 TURN ON TURN OFF SCENE1 TURN ON TURN OFF SCENE 1 TURN ON TURN OFF SCENE2 TURN ON TURN OFF SCENE3 TURN ON TURN OFF SCENE5 TURN ON TURN OFF SCENE6 BACKOUT