Scribd
Upload
155 views2 pages

Paper Plane

The document provides 10 steps to fold an American Lung Association Delta Fighter airplane from a single sheet of paper. It involves first folding the paper in half lengthwise and unfolding it. Then folding down the top corners and folding the edges toward the centerline. Next making valley and wing folds, bending up winglets, and folding flaps on both sides. The final step is forming the 3D shape of the completed airplane.

Uploaded by

sasiaero
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as EHTML, PDF, TXT or read online on Scribd
155 views2 pages

Paper Plane

The document provides 10 steps to fold an American Lung Association Delta Fighter airplane from a single sheet of paper. It involves first folding the paper in half lengthwise and unfolding it. Then folding down the top corners and folding the edges toward the centerline. Next making valley and wing folds, bending up winglets, and folding flaps on both sides. The final step is forming the 3D shape of the completed airplane.

Uploaded by

sasiaero
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as EHTML, PDF, TXT or read online on Scribd
You are on page 1/ 2

Step 1. Use a sheet of 81/2-by-11 inch paper.

Fold the paper in half lengthwise and run thumbnail along the fold to crease it sharply. Now, unfold the paper. Step 2 Fold down the top corners as indicated by the arrows.

Step 1

Step 2

Step 3 Fold the two edges toward the center line, as indicated. Step 4. Make a valley fold in half. Turn the plane 90 degrees as shown in figure of Step 5.

Step 3

Step 4
Step 5 Create a wing crease that begins at the nose as shown. Step 6. Bend up the winglet as shown. Repeat step 5 and 6 for other wing.

Step 5

Step 6

Step 7. Open the model and bring out the flap form the left side layer. Step 8. Fold the triangle so that the lower edge meets the center line.

Step 7

Step 8
Step 9. Repeat similar folding for the upper part of the flap. Step 10.

Step 10 Step 9

Form 3-dimensional shape as shown in figure. The American Lung Association Delta Fighter is complete.

You might also like