100% found this document useful (1 vote)
1K views1 page

Creating CV in Ericsson RBS

To create a new CV, use the command "cvms <cvname>" which will create the CV and place it in the startable state. To check existing CVs, use the command "cvls". To restart Node B, use the command "acc 0 manualrestart" and follow the prompts to select a restart type of COLD and an unplanned cause of UNPLANNED_O_AND_M_ISSUE.

Uploaded by

senjamir
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
100% found this document useful (1 vote)
1K views1 page

Creating CV in Ericsson RBS

To create a new CV, use the command "cvms <cvname>" which will create the CV and place it in the startable state. To check existing CVs, use the command "cvls". To restart Node B, use the command "acc 0 manualrestart" and follow the prompts to select a restart type of COLD and an unplanned cause of UNPLANNED_O_AND_M_ISSUE.

Uploaded by

senjamir
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

For creating new CV: command: cvms <cvname> (This will create new CV and put it in set startable

) If you want check the CVs_command: cvls Restarting Node B: Command: acc 0 manualrestart then follow the below steps after excuting the command acc 0 manualrestart Call action manualrestart on 1 MOs. Are you Sure [y/n] ? y Enter one of the following integers: 0:RESTART_WARM, 1:RESTART_REFRESH, 2:RESTAR T_COLD, 3:RESTART_COLDWTEST: 2 Enter one of the following integers: 0:PLANNED_RECONFIGURATION, 1:UNPLANNED_NODE _EXTERNAL_PROBLEMS, 2:UNPLANNED_NODE_UPGRADE_PROBLEMS, 3:UNPLANNED_O_AND_M_ISSUE , 4:UNPLANNED_CYCLIC_RECOVERY, 5:UNPLANNED_LOCKED_RESOURCES, 6:UNPLANNED_COLD_WI TH_HW_TEST, 7:UNPLANNED_CALL_PROCESSING_DEGRADATION, 8:UNPLANNED_LOW_COVERAGE, 3 0:UPGRADE_BOARD_RESTART: 0 Parameter 3 of 3, restartInfo (string): Name

You might also like