Scribd
Upload
69 views

Line Reactors and Adjustable Speed Drives: Controller

The document discusses line reactors which are used to filter voltage transients and reduce harmonics from adjustable speed drives. Line reactors reduce the line voltage by their rated impedance percentage and installing them can help mitigate transient voltage trips and reduce current harmonics. It's important to evaluate if line reactors are suitable for a specific application based on factors like drive loading and voltage tolerance.

Uploaded by

Rizwan Khan
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
69 views

Line Reactors and Adjustable Speed Drives: Controller

The document discusses line reactors which are used to filter voltage transients and reduce harmonics from adjustable speed drives. Line reactors reduce the line voltage by their rated impedance percentage and installing them can help mitigate transient voltage trips and reduce current harmonics. It's important to evaluate if line reactors are suitable for a specific application based on factors like drive loading and voltage tolerance.

Uploaded by

Rizwan Khan
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Line Reactors and Adjustable Speed Drives

Introduction
A Line reactor is an electrical device that is used to filter out high frequency voltage transients and is installed on each phase in series with an electrical load. A typical line reactor application (see illustration below) is to reduce harmonics and transient voltages on the line side of adjustable speed drives. Line reactors are specified by voltage, power ratings (in horsepower), and percent impedance. Line reactors reduce the line voltage by their rated percent impedance. For example, a 3% line reactor reduces the voltage by 3%.

Transient Voltage Mitigation


A1 A2

B1

B2

Controller

MOTOR

C1

C2

Line Reactors

Voltage transients can occur for a variety of reasons including utility capacitor bank switching or equipment switching. Sometimes, these transients are large enough to elevate an adjustable speed drives DC bus voltage such that the drives control circuitry will sense a trip condition and shut down the drive. In many cases, the installation of 3 5% line reactors may reduce these high frequency transients such that DC bus overcurrent trips are reduced or eliminated altogether.

Reduced Current Harmonics and Line Current


Adjustable speed drives are known to increase current harmonics. These harmonics are sometimes injected back through the electrical supply and may interfere with a buildings electrical distribution system. Harmonics cause the overheating of conductor insulation, which can lead to premature insulation failure. Line reactors will actually attenuate some of the current harmonics, and also reduce the overall line current.

Are Line Reactors The Right Application?


Before installing line reactors, check the following: 1. Assure that the drive is at least 70% loaded. Line reactors installed on lightly loaded adjustable speed drives will not alleviate the transient voltage trips. 2. Assure that the adjustable speed drive can tolerate a reduction in steady state line voltage based on the rated percentage impedance. Most utilities will operate within a + or 5% band above and below nominal voltage levels. If the supply voltage swings down to 5% at some parts of the day, a 5% line reactor will effectively reduce the voltage at the drive input terminals by 10% of nominal. 3. Some adjustable speed drive manufacturers install DC link reactors as a standard component of their products. If so, then a 3% link reactor may be enough to mitigate line voltage transients. Higher impedance ratings may be required for drives without integral DC link reactors. 4. Customer site power factor correction capacitors may have a resonant tuned interaction with utility-switched capacitors that actually amplify the voltage transient magnitude by as much as 2 3 times. Generally a 10 20:1 ratio between utility capacitors and power factor correction capacitors are the range of concern for this resonance effect. 5. Have a consulting electrical engineer evaluate your specific facility to determine if line reactors can be beneficial.

Copyright Hawaiian Electric Company, Inc. 2003

You might also like