Scribd
Upload
1K views1 page

Opcom Throttle Body Reset

The document discusses how to perform an electronic throttle body reset after cleaning or replacing the throttle body, or removing the negative battery terminal or engine control unit. It notes that the procedure adapts the throttle body and is supported on certain engine codes. It lists prerequisites for the reset such as coolant and battery temperatures and no stored trouble codes. Finally, it provides steps to select the engine and start the reset from a special functions menu.

Uploaded by

Drakooola
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

Opcom Throttle Body Reset

The document discusses how to perform an electronic throttle body reset after cleaning or replacing the throttle body, or removing the negative battery terminal or engine control unit. It notes that the procedure adapts the throttle body and is supported on certain engine codes. It lists prerequisites for the reset such as coolant and battery temperatures and no stored trouble codes. Finally, it provides steps to select the engine and start the reset from a special functions menu.

Uploaded by

Drakooola
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Electronic Throttle Body Reset When this is needed

After cleaning, or replacement of the electronic throttle body, the Adaptation of the electronic Throttle Body must be performed. This procedure must also be carried out, when you take off the negative battery terminal, or replace the engine control unit!

Which engine codes are supports this opration



Z10XE Z12XE Z18XE Z18XEL Z20LET

Prerequisities

The ECT (coolant temperature) is at normal (warm, about 85 C) temperature. The engine is not running. Throttle pedal is idle position (please, do not operate the gas pedal during ) Battery voltage is greater, than 11 V There is no DTC stored in the engine control unit

Performing the Throttle Body Adaptation



Choose the engine Click on the [Special function] button. Click on the [Reset learned values] button. Click on the [Start] button.

You might also like