Scribd
Upload
86 views3 pages

Automatic Transmission Fluid: Adjustment

This document provides instructions for refilling the automatic transmission fluid on a vehicle with an A750E or A750F transmission. It outlines the process which includes checking and, if needed, adjusting the fluid level. The level should be checked after the fluid reaches an operating temperature of 46°C to 56°C. If the level is low, additional fluid must be added in 0.4 liter increments until it reaches the proper level as seen at the overflow tube.

Uploaded by

Saeful Mujab
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
86 views3 pages

Automatic Transmission Fluid: Adjustment

This document provides instructions for refilling the automatic transmission fluid on a vehicle with an A750E or A750F transmission. It outlines the process which includes checking and, if needed, adjusting the fluid level. The level should be checked after the fluid reaches an operating temperature of 46°C to 56°C. If the level is low, additional fluid must be added in 0.4 liter increments until it reaches the proper level as seen at the overflow tube.

Uploaded by

Saeful Mujab
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

AT4

AUTOMATIC TRANSMISSION (A750E, A750F) AUTOMATIC TRANSMISSION FLUID

Refill Plug

AUTOMATIC TRANSMISSION FLUID


AT14501

ADJUSTMENT
1.
S S S S

Overflow Plug
D14137

BEFORE TRANSMISSION FILL This transmission requires Toyota Genuine ATF WS transmission fluid. After servicing the transmission, you must refill the transmission with the correct amount of fluid. Maintain the vehicle in a horizontal position while adjusting fluid level. On vehicles equipped with active suspension, turn the suspension control switch OFF if you jack up the vehicle while the engine is running. Proceed to step 2 if you replaced the entire transmission, transmission pan, drain plug, valve body and/or torque converter. Proceed to step 3 after removing the refill plug if you replaced the transmission hose and/or output shaft oil seal. TRANSMISSION PAN FILL Remove the refill plug and overflow plug. Fill the transmission through the refill hole until fluid begins to trickle out of the overflow tube. Reinstall the overflow plug. TRANSMISSION FILL Fill the transmission with the correct amount of fluid as listed in the table below. Reinstall the refill plug to avoid fluid splash.
Repair Fill Amount 0.6 L (0.63 US qts, 0.53 Imp qts) 0.4 L (0.42 US qts, 0.35 Imp qts) 1.3 L (1.37 US qts, 1.14 Imp qts) 3.9 L (4.12 US qts, 3.43 Imp qts) 5.3 L (5.60 US qts, 4.66 Imp qts) 7.2 L (7.61 US qts, 6.34 Imp qts)

2. (a) (b)
Specified Fluid Level Overflow Tube

(c) 3. (a) (b)

D14351

Transmission hose and pipe removal Output shaft oil seal replacement Transmission pan and drain plug removal Transmission valve body removal Torque converter removal Entire transmission assembly

HINT: If you cannot add the listed amount of fluid, do the following: S Install the refill plug. S Allow the engine to idle with the air conditioning OFF. S Move the shift lever through entire gear range to circulate fluid. S Wait for 30 seconds with the engine idling. S Stop the engine. S Remove the refill plug and add fluid. S Reinstall the refill plug.

AT5
AUTOMATIC TRANSMISSION (A750E, A750F) AUTOMATIC TRANSMISSION FLUID

4. (a) (b) 5. (a)

FLUID CIRCULATION Allow the engine to idle with the air conditioning OFF. Move the shift lever through entire gear range to circulate fluid. FLUID TEMPERATURE CHECK With handheld tester (1) Connect the handheld tester to the DLC3. (2) Select the tester menus: OBD/MOBD, ENGINE, DATA LIST and A/T. (3) Check A/T OIL TEMP. (4) Allow the engine to idle until the fluid temperature reaches 46_C (115_F).

DLC3:

CG

(b)

9 10 11 12 13 14 15 16

TC

D13649

Without handheld tester (Using A/T OIL TEMP indicator) (1) Create a short circuit between CG (4) and TC (13) of the DLC3 terminals using SST. SST 0984318040 (2) Move the shift lever back and forth between N and D at 1.5 seconds interval for six seconds. (3) The A/T OIL TEMP indicator comes on for two seconds when the combination meter starts to detect the fluid temperature. (4) The A/T OIL TEMP indicator comes on again when the fluid temperature reaches 46_C (115_F) and blinks when it exceeds 56_C (130_F). (5) Allow the engine to idle until the fluid temperature reaches 46_C (115_F).

HINT: The fluid temperature should be less than 30_C (86_F) before check the fluid temperature.

Specified Fluid Level

Overflow Tube

D14351

6. FLUID LEVEL CHECK NOTICE: The fluid temperature must be between 46_C (115_F) and 56_C (130_F) to check the fluid level. (a) Remove the overflow plug with the engine idling. (b) Check that the fluid comes out of the overflow tube. If fluid does not come out, proceed to step 7. If fluid comes out, wait until the overflow slows to a trickle and proceed to step 8.

AT6
AUTOMATIC TRANSMISSION (A750E, A750F) AUTOMATIC TRANSMISSION FLUID

7. (a) (b) (c) (d) (e) (f) 8. (a) (b) (c)

TRANSMISSION REFILL Install the overflow plug. Stop the engine. Remove the refill plug. Add 0.4 liters (0.42 US qts, 0.35 lmp qts) of fluid. Allow the engine to idle and wait for 10 seconds. Proceed to step 6. COMPLETE Install the overflow plug with a new gasket. Torque: 20 Nm (205 kgfcm, 15 ftlbf) Stop the engine. Install the refill plug with a new gasket. Torque: 39 Nm (400 kgfcm, 29 ftlbf)

You might also like