Scribd
Upload
954 views1 page

Cablemaster CM-7 - Gear Replacement Guide

1. Remove internal parts from housing except gear shafts and clean out original grease. 2. Install spacers onto each shaft as specified and install new and original cluster gears. 3. Install main shaft gear assembly into bearing and new gasket. 4. Add new grease around gears, install cover, and run unit to confirm low motor current under no load.

Uploaded by

Glendinning Products, LLC.
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
954 views1 page

Cablemaster CM-7 - Gear Replacement Guide

1. Remove internal parts from housing except gear shafts and clean out original grease. 2. Install spacers onto each shaft as specified and install new and original cluster gears. 3. Install main shaft gear assembly into bearing and new gasket. 4. Add new grease around gears, install cover, and run unit to confirm low motor current under no load.

Uploaded by

Glendinning Products, LLC.
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

1 - Remove all internal parts from housing, except gear shafts.

2 - Clean out all the original grease from housing. (The main reason for this is to remove any broken gear parts from the housing.) 3 - Install .03" spacer (#72406) onto each shaft, Make sure the original spacers have been removed, or just leave them on the shaft, and do not add anymore spacers as mentioned above. 4 - Install new Cluster Gear A (#WP053) onto shaft 5 - Install original Cluster Gear B (WP052) onto shaft with small gear toward housing 6 - Install .03" Spacer (#72406) and .406" spacer (#51422) onto shaft with Cluster Gear B 7 - Install .03" Spacer (#72406), new Pivot Gear Assembly (#WP010), and another .03" Spacer (#72406) onto shaft with Cluster Gear A 8 - Install Main Shaft Gear Assembly (#WP125) into main shaft bearing 9 - Install New gearbox Gasket GMP # 87404 10 - Add new grease around all gears 11 - Install Gearbox cover (not shown) and 8/32 hex screws (some extra screws supplied) 12 - Run unit and confirm that under no load the motor current is only 1 - 2 amps.

GLENDINNING MARINE PRODUCTS INC.


740 CENTURY CIRCLE, CONWA Y SC 29526 P H 843 399 61 46 FA X 843 399 5005

CM-7 Pivot Gear rebuild kit and assembly Instructions


DWG NO.

GMP Part # WP066


SIZE DRAWN BY SCALE REV. DATE

PG

7/1/2009

You might also like