Scribd
Upload
195 views3 pages

Electrical Power Test Paper-I

This document contains a unit test for a fifth semester Electrical Power course. The test has 4 questions related to transmission line capacitance, inductance, skin effect, proximity effect, and calculating voltage regulation using a T-circuit model. It provides the questions, figures to reference, and maximum marks for each part of the test.

Uploaded by

hksaifee
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
195 views3 pages

Electrical Power Test Paper-I

This document contains a unit test for a fifth semester Electrical Power course. The test has 4 questions related to transmission line capacitance, inductance, skin effect, proximity effect, and calculating voltage regulation using a T-circuit model. It provides the questions, figures to reference, and maximum marks for each part of the test.

Uploaded by

hksaifee
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

COLLEGE OF ENGINEERING AND TECHNOLOGY DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING

UNIT TEST: FIRST SUBJECT: ELECTRICAL POWER I MAX MARKS: 27 SEMESTER: FIFTH

COLLEGE OF ENGINEERING AND TECHNOLOGY DEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING


UNIT TEST: FIRST SUBJECT: ELECTRICAL POWER I MAX MARKS: 27 SEMESTER: FIFTH

Q 1(a) Derive an expression for the capacitance of three phase symmetrical line. (7M) Q 1(b) A double circuit three phase line is shown in figure 1. The conductors a, a; b, b and c, c belong to the same phase respectively. The radius of each conductor is 5.3cm. Find the inductance of the double-circuit line in mH/km/phase. (7M) a b c a b c

Q 1(a) Derive an expression for the capacitance of three phase symmetrical line. (7M) Q 1(b) A double circuit three phase line is shown in figure 1. The conductors a, a; b, b and c, c belong to the same phase respectively. The radius of each conductor is 5.3cm. Find the inductance of the double-circuit line in mH/km/phase. (7M) a b c a b c

8m

8m

8m

8m

8m

8m

8m

8m

8m

8m

Figure 1 OR Q 2(a) Write short notes on: (a) Skin effect; (b) Proximity effect.

Figure 1 OR Q 2(a) Write short notes on: (a) Skin effect; (b) Proximity effect.

(7M)

(7M)

Q 2(b) figure 2 below shows two conductors A and B made of filaments. The radii of filaments of A and B are 3cm and 4cm respectively. Calculate the loop inductance of the line if it is 100m long. (7M)

Q 2(b) figure 2 below shows two conductors A and B made of filaments. The radii of filaments of A and B are 3cm and 4cm respectively. Calculate the loop inductance of the line if it is 100m long. (7M)

0.5m a b

1.5m c

2m d

0.3m e a

0.5m b

1.5m c

2m d

0.3m e

Conductor A Figure 2

Conductor B

Conductor A Figure 2

Conductor B

Q 3(a) Calculate the inductance of a three phase double circuit transmission line shown in figure 3 with self GMD of single conductor equal to 0.467cm. (7M)

Q 3(a) Calculate the inductance of a three phase double circuit transmission line shown in figure 3 with self GMD of single conductor equal to 0.467cm. (7M)

a
2m

c
2m

b
2m

b
2m

c
6m

c
6m

Figure 3 Q 3(b) What is mean by the term transposition? Mention its advantages and drawbacks? (6M) OR Q 4(a) Explain the method of geometric mean distances (GMD) to calculate the inductance of transmission line. (7M) Q 4(b) A 200 km long, 3 phase overhead line has a resistance of 48.7 /phase, Inductive reactance of 80.20 /phase and capacitance (line to neutral) 8.42nF per km. It supplies a load of 13.5MW at a voltage of 88kV and Power factor 0.9 lagging. Using nominal T-circuit find sending end Voltage, current and regulation. (6M)

Figure 3 Q 3(b) What is mean by the term transposition? Mention its advantages and drawbacks? (6M) OR Q 4(a) Explain the method of geometric mean distances (GMD) to calculate the inductance of transmission line. (7M) Q 4(b) A 200 km long, 3 phase overhead line has a resistance of 48.7 /phase, Inductive reactance of 80.20 /phase and capacitance (line to neutral) 8.42nF per km. It supplies a load of 13.5MW at a voltage of 88kV and Power factor 0.9 lagging. Using nominal T-circuit find sending end Voltage, current and regulation. (6M)

BEST OF LUCK

BEST OF LUCK

You might also like