Scribd
Upload
33 views1 page

Tos Test 1

This document contains instructions for analyzing a beam using the moment distribution method and drawing the shear force and bending moment diagrams. It asks the student to: 1) Analyze the beam shown using the moment distribution method 2) Draw the shear force diagram and bending moment diagram for the beam 3) The beam is given in a diagram within the document

Uploaded by

yogesh_kherde8381
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
33 views1 page

Tos Test 1

This document contains instructions for analyzing a beam using the moment distribution method and drawing the shear force and bending moment diagrams. It asks the student to: 1) Analyze the beam shown using the moment distribution method 2) Draw the shear force diagram and bending moment diagram for the beam 3) The beam is given in a diagram within the document

Uploaded by

yogesh_kherde8381
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

4. (a) Analyze the beam shown below by Moment Distribution Moment. Draw SFD & BMD.

13

PROF RAM MEGHE COLLEGE OF ENGINEERING & MANAGEMENT, BADNERA


Fourth Semester B.E. (Civil Engg.) Examination Test No. 1 Summer-2012 Theory Of Structure-I (4SC3) Time: [1.30 hrs] [Max. Marks: 27] 1. (a) Differentiate between statically determinate & indeterminate structures. 4

(b) A fixed beam of span 12 meters caries UDL of 20 KN/M over right half of the span and carries an point load of 50 KN at 2 meter from left end. Find fixed end moments at support and draw BMD and SFD. 10 OR 2. (a) State only three advantages of fixed beam. 2 (b) A fixed beam of span 6 meters caries UDL of 20 KN/M over entire span and carries an point load of 50 KN at center of the span, with right end sinks by 15 mm. Find fixed end moments at support & draw BMD & SFD. Find out point of contraflexure. 12

3. (a) Define following terms 1) Distribution factor 2) Unbalanced moment (b) Analyze the beam shown below by Moment Distribution Moment. Draw SFD & BMD. 2 11

You might also like