Scribd
Upload
190 views3 pages

Material Transfer in Rotary Kilns

This document contains calculations for determining the particle residence time in a kiln. It provides input values for the kiln's rotational speed, radius, tilt angle, solid material angle of repose, dam height, length, number of length divisions, and volumetric flow rate. The calculations result in a residence time of 3,983 seconds based on a Froude number of 0.00126 and a bed depth to radius ratio that decreases from 0.12 to 0.02 over the length of the kiln.

Uploaded by

Mehrdad Aminkazemi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
190 views3 pages

Material Transfer in Rotary Kilns

This document contains calculations for determining the particle residence time in a kiln. It provides input values for the kiln's rotational speed, radius, tilt angle, solid material angle of repose, dam height, length, number of length divisions, and volumetric flow rate. The calculations result in a residence time of 3,983 seconds based on a Froude number of 0.00126 and a bed depth to radius ratio that decreases from 0.12 to 0.02 over the length of the kiln.

Uploaded by

Mehrdad Aminkazemi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 3

By : Mehrdad Aminkazemi , Mechanical engineer

[email protected]
Particles Residence Time ( Sec. )=

Input values

3,983

Total Bed Volume (m3) Param. 1 2 n= 0.5 Rpm R= 4.5 m Beta= 1 Deg. Gamma= Deg. Hdam= m L= m No.= Q= m3/hr 32 0.2 190 500 200.00 0.055555556 0.017453293 0.558505361 Input Value 0.052333333 Unit Rpm m Remark Kiln Rotational Speed Kiln Internal Radius Kiln Volu. Occupied Percentage ( % )= 1.83 221.27

3 4 5 6 7 8

Deg. Deg. m m No. M3/Hr

Kiln Tilt Angle Solid Material Angle Of Repose Dam Height At The End Of Kiln Kiln Length Number Of Kiln Length Divisions Kiln Volumetric Flow Rate

Froude Number 0.00126

[email protected]
bed depth / R

0.12

0.1

0.08

n= Rpm R= m Beta= Deg. Gamma= Deg. Hdam= m L= m Q= M3/Hr

0.5 4.5 1.00 32 0.2 190 200.00

BD / R

0.06

Fr= 0.0012576 Resid. Time= 3983 Sec.

0.04

0.02

0 0 50

X from end of kiln - m 100

150

200

You might also like