MSDS 45812N

MATERIAL SAFETY DATA SHEET
SLIDE PRODUCTS, INC.

430 S. WHEELING ROAD
WHEELING, IL 60090
PRODUCT NAME: SLIDE URETHANE MOLD RELEASE 45812N
EMERGENCY TELEPHONE: 800-535-5053 REVISION DATE: 9-01-06

INFORMATION TELEPHONE: 847-541-7220 PRODUCT NUMBER: 45812N
FAX NUMBER: 847-541-7986 D.U.N.S. NUMBER: 00-299-4168
PREPARED BY: JIM ARMSTRONG
SECTION I. IDENTIFICATION
CHEMICAL NAME: SYNTHETIC LUBRICANT
CHEMICAL FAMILY: HYDROCARBON
FORMULA: 54351
SYNONYMS: SLIDE URETHANE RELEASE
DOT HAZARD CLASSIFICATION: ORM-D
DOT SHIPPING MANE: CONSUMER COMMODITY
CHEMICAL ABSTRACT REGISTRY NUMBER: 8042-47-5
IDENTIFICATION NUMBER: NONE
H.M.I.S. RATING: 1,3,0,B
SECTION II. PHYSICAL DATA

BOILING POINT: N/A
FREEZING POINT: <-50’F.
SPECIFIC GRAVITY (H20 =1): .81
WEIGHT PER GALLON @ 60 F.: 6.79
VAPOR PRESSURE @ 70 F. (MM HG): N/A
VAPOR DENSITY (AIR = 1): >1
SOLUBILITY IN WATER, % BY WT.: PARTIALLY SOLUBLE
PERCENT VOLATILE BY WEIGHT: 94
EVAPORATION RATE (MINUTES):
APPEARANCE AND ODOR: CLEAR, OILY FLUID, COLORLESS , SLIGHT ETHEREAL ODOR.
SECTION III. HAZARDOUS INGREDIENTS

MATERIAL: APPROX. WEIGHT %: CAS NUMBER: PEL (OSHA)
SYNTHETIC LUBRICANT 1-8 MIXTURE N/A
DIMETHYL ETHER 45-55 115-10-6 1000 PPM
1,1,1,2-TETRAFLUOROETHANE45-55 811-97-2 1000 PPM
***CONTAINS NO OZONE DEPLETING CHEMICALS***

ALL COMPONENTS OF THIS PRODUCT ARE LISTED ON THE TSCA DIRECTORY
SECTION IV. FIRE AND EXPLOSION HAZARD DATA

FLAMMABLE LIMITS IN AIR: LEL: UEL: (VOLUME %)
FLASH POINT: N/A
AEROSOL FLAME PROJECTION TEST: 18” FLAME PROJECTION AS DETERMINED BY THE AEROSOL
FLAME PROJECTION TEST.
EXTINGUISHING MEDIA: DRY CHEMICAL, CO2, FOAM PARAGRAPH 191.15
SPECIAL FIRE FIGHTING PROCEDURES: SELF-CONTAINED BREATHING APPARATUS
UNUSUAL FIRE & EXPLOSION HAZARDS: AEROSOLS MAY RUPTURE VIOLENTLY AT TEMPERATURES
ABOVE 120 DEGREES F.
MATERIAL SAFETY DATA SHEET SLIDE PRODUCTS, INC. PAGE 2
45812N
SECTION V. REACTIVITY DATA

STABILITY: STABLE
INCOMPATIBILITY (MATERIALS TO AVOID): POWDERED OR ALKALINE EARTH METALS
HAZARDOUS COMBUSTION BY-PRODUCTS: HF AND OTHER FLUORINE COMPOUNDS
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
CONDITIONS TO AVOID: OPEN FLAMES AND HIGH TEMPERATURES
SECTION VI. HEALTH HAZARD DATA

THRESHOLD LIMIT VALUE: 1000 PPM
*EFFECTS OF OVEREXPOSURE*
INGESTION (SWALLOWING): N/A
INHALATION: EXCESSIVE INHALATION CAN PRODUCE DIZZINESS, NAUSEA, AND HEADACHE.
SKIN CONTACT: CONCENTRATED SPRAY MAY CAUSE FREEZING OF SKIN AREA
EYE CONTACT: TEMPORARY IRRITATION
*EMERGENCY AND FIRST AID PROCEDURES*
SKIN: WASH WITH SOAP AND WATER

INHALATION: REMOVE TO FRESH AIR LOCATION
EYES: FLUSH WITH PLENTY OF WATER, CALL PHYSICIAN
SECTION VII. SPILL OR LEAK PROCEDURES

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: REMOVE LEAKING CONTAINER TO
OUTSIDE DISPOSAL SITE.
WASTE DISPOSAL METHOD: EMPTY FULLY, INCLUDING GAS PRESSURE. DO NOT PUNCTURE OR
INCINERATE. CAN BE RECYCLED OR ALTERNATIVELY REMOVED TO A SANITARY LANDFILL IN
MOST LOCALITIES. CHECK APPLICABLE REGULATIONS.
SECTION VIII. SPECIAL PROTECTION INFORMATION

RESPIRATORY PROTECTION (SPECIFY TYPE): NOT NEEDED WITH ADEQUATE VENTILATION.
VENTILATION: ADEQUATE VENTILATION NEEDED.
PROTECTIVE GLOVES: RECOMMENDED BUT NOT REQUIRED.
EYE PROTECTION: PROPER EYE CARE SHOULD BE PRACTICED IN ALL INDUSTRIAL OPERATIONS.
OTHER PROTECTIVE EQUIPMENT: AS YOUR COMPANY REQUIRES.
SECTION IX. SPECIAL PRECAUTIONS

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: STORE INDOORS AWAY FROM DIRECT
SUNLIGHT, BELOW 120’F. DO NOT DROP, PUNCTURE, OR INCINERATE.
OTHER PRECAUTIONS: DO NOT SPRAY DIRECTLY INTO FLAME. DO NOT SMOKE WHILE USING
PRODUCT. DO NOT SPRAY ON FLOORS.
SECTION X. CARCINOGENIC HAZARD

NO COMPONENT IN THIS PRODUCT HAS BEEN LISTED AS A CARCINOGEN BY IARU, N.T.P., OSHA OR
ACGIH.
THIS DATA IS OFFERED IN GOOD FAITH AS TYPICAL VALUES AND NOT AS A PRODUCT
SPECIFICATION. NO WARRANTY, EXPRESS OR IMPLIED, IS HEREBY MADE. THE RECOMMENDED
INDUSTRIAL HYGIENE AND SAFE HANDLING PROCEDURES ARE BELIEVED TO BE GENERALLY
APPLICABLE. HOWEVER, EACH USER SHOULD REVIEW THESE RECOMMENDATIONS IN THE
SPECIFIC CONTEXT OF THE INTENDED USE, AND DETERMINE WHETHER THEY ARE APPROPRIATE .
THE INFORMATION CONTAINED IN THIS MATERIAL SAFETY DATA SHEET IS BELIEVED TO BE
CORRECT AS OF THIS DATE. THE REGULATIONS PROMULGATED BY OSHA FOR HAZARD
COMMUNICATION, 20 CFR 1910.1200, AS WELL S SEVERAL STATE AND LOCAL LAWS AND
REGULATIONS, HAVE BEEN CONSULTED IN PREPARING THIS M.S.D.S.

MSDS 45812N

Uploaded by

Copyright:

Available Formats

MSDS 45812N

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

MSDS 45812N

Uploaded by

Copyright:

Available Formats

MATERIAL SAFETY DATA SHEET

SLIDE PRODUCTS, INC.

PRODUCT NAME: SLIDE URETHANE MOLD RELEASE 45812N

EMERGENCY TELEPHONE: 800-535-5053 REVISION DATE: 9-01-06

SECTION II. PHYSICAL DATA

SECTION III. HAZARDOUS INGREDIENTS

CONTAINS NO OZONE DEPLETING CHEMICALS

SECTION IV. FIRE AND EXPLOSION HAZARD DATA

SECTION V. REACTIVITY DATA

SECTION VI. HEALTH HAZARD DATA

EMERGENCY AND FIRST AID PROCEDURES

SKIN: WASH WITH SOAP AND WATER

SECTION VII. SPILL OR LEAK PROCEDURES

SECTION VIII. SPECIAL PROTECTION INFORMATION

SECTION IX. SPECIAL PRECAUTIONS

SECTION X. CARCINOGENIC HAZARD

You might also like