MSDS 40616T

MATERIAL SAFETY DATA SHEET
SLIDE PRODUCTS, INC.

430 S. WHEELING ROAD
WHEELING, IL 60090
PRODUCT NAME: SLIDE EPOXEASE MOLD RELEASE 40616T
EMERGENCY TELEPHONE: 800-535-5053 REVISION DATE: 9-01-06

INFORMATION TELEPHONE: 847-541-7220 PRODUCT NUMBER: 40616T
FAX NUMBER: 847-541-7986 D.U.N.S. NUMBER: 00-299-4168
PREPARED BY: JIM ARMSTRONG
SECTION I. IDENTIFICATION
CHEMICAL NAME: SYNTHETIC WAX DISPERSION
CHEMICAL FAMILY: SYNTHETIC WAX
FORMULA: 40616T
SYNONYMS: EPOXEASE
DOT HAZARD CLASSIFICATION: ORM-D
DOT SHIPPING NAME: CONSUMER COMMODITY
CHEMICAL ABSTRACT REGISTRY NUMBER: N/A, MIXTURE
IDENTIFICATION NUMBER: NONE
H.M.I.S. RATING: 2,3,0,B
SECTION II. PHYSICAL DATA
DATA IN SECTION II APPLIES TO CONCENTRATE BEFORE ADDING PROPELLANT

BOILING POINT: 103-337 DEGREES F.
FREEZING POINT: < -40 DEGREES F.
SPECIFIC GRAVITY: (H20 =1): 1.02
WEIGHT PER GALLON @ 60 F.: 8.58
VAPOR PRESSURE @ 70 F. (MM HG): 350
VAPOR DENSITY (AIR =1): >1
SOLUBILITY IN WATER, % BY WEIGHT: 90
EVAPORATION RATE (MINUTES): 20
APPEARANCE AND ODOR: OPAQUE BROWN LIQUID – CHLORINATED SOLVENT ODOR
SECTION III. HAZARDOUS INGREDIENTS

MATERIAL: APPROX. WT. % CAS NUMBER: PEL(OSHA)
TRICHLOROETHYLENE** 55-65 79-01-6 100 PPM
PROPANE A-108 10-20 74-98-6 1000 PPM
ALIPHATIC NAPHTHA 20-25 68513-03-1* 130 PPM
SYNTHETIC WAX 1-5 MIXTURE N/A
** CONTAINS NO OZONE DEPLETING CHEMICALS **
ALL COMPONENTS OF THIS PRODUCT ARE LISTED ON THE TSCA DIRECTORY
**)SEE SECTIONS X AND XI FOR DETAILED CAUTIONS
SECTION IV. FIRE AND EXPLOSION HAZARD DATA

FLAMMABLE LIMITS IN AIR: LEL: 1.0 UEL: 9.5 (VOLUME %)
FLASH POINT: N/A
SPECIAL FIRE FIGHTING PROCEDURES: CHLORINATED HYDROCARBON FORM HCI AND TRACES OF
PHOSGENE UPON PYROLYSIS.
UNUSUAL FIRE & EXPLOSION HAZARDS: AEROSOLS MAY RUPTURE VIOLENTLY AT TEMPERATURES
ABOVE 120’ F.
SECTION V. REACTIVITY DATA

STABILITY: STABLE
INCOMPATIBILITY (MATERIALS TO AVOID): NONE KNOWN
HAZARDOUS COMBUSTION BY-PRODUCTS: SEE SECTION IV
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
CONDITIONS TO AVOID: TEMP. ABOVE 120’ F. – DIRECT SUNLIGHT
MATERIAL SAFETY DATA SHEET SLIDE PRODUCTS, INC. PAGE 2
40616T
SECTION VI. HEALTH HAZARD DATA

THRESHOLD LIMIT VALUE: 100 PPM
• EFFECTS OF OVEREXPOSURE
INGESTION (SWALLOWING): N/A

INHALATION: GIDDINESS, NAUSEA, POSSIBLE NARCOSIS
SKIN CONTACT: DEFATTING OF SKIN
EYE CONTACT: TEMPORARY IRRITATION
• EMERGENCY AND FIRST AID PROCEDURES *
SKIN: WASH WITH SOAP AND WATER, APPLY HAND CREAM

INHALATION: REMOVE TO FRESH-AIR LOCATION AWAY FROM EXPOSURE
EYES: RINSE WITH PLENTY COOL CLEAN WATER UNTIL IRRITATION SUBSIDES
SECTION VII. SPILL OR LEAK PROCEDURES

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: REMOVE LEAKING CONTAINER TO
OUTSIDE DISPOSAL SITE.
WASTE DISPOSAL METHOD: EMPTY FULLY, INCLUDING GAS PRESSURE. DO NOT PUNCTURE OR
INCINERATE. CAN MAY BE RECYCLED OR ALTERNATIVELY REMOVED TO A SANITARY LANDFILL –
CHECK APPLICABLE REGULATIONS.
SECTION VIII. SPECIAL PROTECTON INFORMATION

RESPIRATORY PROTECTION: (SPECIFY TYPE): NOT NEEDED WITH ADEQUATE VENTILATION.
VENTILATION: ADEQUATE VENTILATION RECOMMENDED
PROTECTIVE GLOVES: RECOMMENDED BUT NOT REQUIRED
EYE PROTECTION: PROPER EYE CARE IS NEEDED IN ALL INDUSTRIAL OPERATIONS.
OTHER PROTECTIVE EQUIPMENT: AS REQUIRED BY YOUR COMPANY
SECTION IX. SPECIAL PRECAUTIONS

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: STORE INDOORS AWAY FROM HEAT
SOURCES OR DIRECT SUNLIGHT – DO NOT PUNCTURE OR INCINERATE – DO NOT DROP!!
OTHER PRECAUTIONS: AVOID OVER-SPRAYING ONTO FLOORS OR SLIPPERY SURFACE MAY
RESULT.
SECTION X. EFFECTS OF PROLONGED EXPOSURE

TRICHLOROETHYLENE: PROLONGED EXPOSURE MAY CAUSE SKIN IRRITATION. MAY BE
ABSORBED THROUGH SKIN TO SOME DEGREE. EXCESSIVE INHALATION CAUSES IRRITATION TO
UPPER RESPIRATORY TRACT AND MAY INCREASE SENSITIVITY TO EPINEPHRINE, AND INCREASED
MYOCARDIAL IRRITABILITY (IRREGULAR HEART BEATS). MINIMAL ANESTHETIC EFFECTS AT
LEVELS OF 200-400 PPM, DIZZINESS AT HIGHER LEVELS; AT 1000-2000 PPM UNCONSCIOUSNESS AND
DEATH. CONCENTRATIONS OVER 6000 PPM ARE IMMEDIATELY HAZARDOUS TO LIFE. LC50 FOR
RATS IS 12,500 PPM FOR 4 HOURS. ALCOHOL WILL ENHANCE ADVERSE EFFECTS. EXCESSIVE
EXPOSURE MAY CAUSE LIVER OR KIDNEY EFFECTS; LOWER CONCENTRATIONS ABOVE ACCEPTED
GUIDELINES MAY CAUSE CENTRAL OR PERIPHERAL NERVOUS SYSTEM EFFECTS.
SECTION XI. CARCINOGENIC HAZARD

CALIFORNIA PROPOSITION 65: THIS PRODUCT CONTAINS A CHEMICAL KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE CANCER.
PROLONGED EXPOSURE ABOVE THE OSHA PERMISSIBLE LIMITS MAY RESULT IN LIVER AND
KIDNEY DAMAGE. TRICHLOROETHYLENE HAS BEEN EXTENSIVELY STUDIED FOR CHRONIC
EFFECTS IN ANIMALS. WHILE THERE ARE STUDIES IN WHICH TUMORS WERE INDUCED IN MICE,
THERE IS NO DOCUMENTED EVIDENCE THAT EXPOSURE TO TRICHLOROETHYLENE PRODUCES
CANCER IN HUMANS. TRICHLOROETHYLENE IS LISTED IN GROUP 2A BY IARC BUT IS NOT LISTED
BY NTP OR OSHA.
MATERIAL SAFETY DATA SHEET SLIDE PRODUCTS, INC. PAGE 3
40616T
SECTION XII. REPORTING REQUIREMENTS

THIS PRODUCT CONTAINS THE FOLLOWING CHEMICAL(S) REQUIRED TO BE REPORTED UNDER SARA
TITLE III, SECTION 313: TRICHLOROETHYLENE, CAS NUMBER 79-01-6. REPORTING REQUIREMENTS
UNDER CERCLA PART 302 ARE 100 POUNDS. ANY RELEASES WHICH EXCEED THE RQ MUST BE
REPORTED TO THE NATIONAL RESPONSE CENTER AT 800-424-8802.
THIS DATA IS OFFERED IN GOOD FAITH AS TYPICAL VALUES AND NOT AS A PRODUCT
SPECIFICATION. NO WARRANTY, EXPRESS OR IMPLIED, IS HEREBY MADE. THE RECOMMENDED
INDUSTRIAL HYGIENE AND SAFE HANDLING PROCEDURES ARE BELIEVED TO BE GENERALLY
APPLICABLE. HOWEVER, EACH USER SHOULD REVIEW THESE RECOMMENDATIONS IN THE
SPECIFIC CONTEXT OF THE INTENDED USE AND DETERMINE WHETHER THEY ARE APPROPRIATE.
THE INFORMATION CONTAINED IN THIS MATERIAL SAFETY DATA SHEET IS BELIEVED TO BE
CORRECT AS OF THIS DATE. THE REGULATIONS PROMULGATED BY OSHA FOR HAZARD
COMMUNICATION, 29 CFR 1910.1200, AS WELL AS SEVERAL STATE AND LOCAL LAWS AND
REGULATIONS, HAVE BEEN CONSULTED IN PREPARING THIS M.S.D.S.

MSDS 40616T

Uploaded by

Copyright:

Available Formats

MSDS 40616T

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

MSDS 40616T

Uploaded by

Copyright:

Available Formats

MATERIAL SAFETY DATA SHEET

SLIDE PRODUCTS, INC.

PRODUCT NAME: SLIDE EPOXEASE MOLD RELEASE 40616T

EMERGENCY TELEPHONE: 800-535-5053 REVISION DATE: 9-01-06

SECTION II. PHYSICAL DATA

DATA IN SECTION II APPLIES TO CONCENTRATE BEFORE ADDING PROPELLANT

SECTION III. HAZARDOUS INGREDIENTS

SECTION IV. FIRE AND EXPLOSION HAZARD DATA

SECTION V. REACTIVITY DATA

SECTION VI. HEALTH HAZARD DATA

INGESTION (SWALLOWING): N/A

• EMERGENCY AND FIRST AID PROCEDURES *

SKIN: WASH WITH SOAP AND WATER, APPLY HAND CREAM

SECTION VII. SPILL OR LEAK PROCEDURES

SECTION VIII. SPECIAL PROTECTON INFORMATION

SECTION IX. SPECIAL PRECAUTIONS

SECTION X. EFFECTS OF PROLONGED EXPOSURE

SECTION XI. CARCINOGENIC HAZARD

SECTION XII. REPORTING REQUIREMENTS

You might also like