Scribd
Upload
51 views

Adonis SNMP Configuration Guide: User Password

This document provides instructions for configuring SNMP settings on Adonis appliances. It outlines 8 steps: 1) Log in with the default credentials, 2) Check the existing SNMP configuration, 3) Verify the CLI version, 4) Enter SNMP configuration mode, 5) Configure SNMP server, version and community string for versions 6.6 and 5.5, 6) Save the configuration, 7) Check the SNMP configuration, and 8) Save and exit.

Uploaded by

Vikas Gupta
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
51 views

Adonis SNMP Configuration Guide: User Password

This document provides instructions for configuring SNMP settings on Adonis appliances. It outlines 8 steps: 1) Log in with the default credentials, 2) Check the existing SNMP configuration, 3) Verify the CLI version, 4) Enter SNMP configuration mode, 5) Configure SNMP server, version and community string for versions 6.6 and 5.5, 6) Save the configuration, 7) Check the SNMP configuration, and 8) Save and exit.

Uploaded by

Vikas Gupta
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

Adonis SNMP Configuration Guide

1. Login the Adonis appliances through your admin access. User name: user Password : password

2. Type show snmp for check the existing snmp configuration 3. After successful login the system, type verison CLI command for check the version 4. Type configure snmp CLI command for SNMP configuration in Adonis

4. After type set trap CLI command for configure the SNMP server, SNMP version and community string. This is applicable for version 6.6 and version 5.5

5. After type set serverconfig CLI command for configure the SNMP version, community string, location, Model and server name. This is applicable for version 6.6 6. Type update CLI command for save the configuration.

Or
5. After type following CLI command for configure the SNMP version, community string, location, Model and server name. This is applicable for version 5.5 set username AGTTCSMNS set password AGTTCSMNS set sysname new.server set syscontact [email protected] set syslocation location name

6. Type update CLI command for save the configuration.

7. Type show for check the snmp configuration

8. Type save for save the configuration and exit the snmp configuration mode and type exit for exit the login

You might also like