Scribd
Upload
505 views1 page

Configuração Digit - Optitex

1. The document provides instructions for setting up a Digitizer device by navigating menus and configuring parameters according to a provided example. 2. Users are instructed to use cursor buttons to select the "SET UP" menu and then press additional buttons to configure 25 indicator lights to match a given parameter example. 3. The example parameter provided consists of binary values for settings like mode, format, baud rate, and parity that should be entered by turning indicator lights on or off according to whether the given value is a 1 or 0.

Uploaded by

Lucas Santos
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
505 views1 page

Configuração Digit - Optitex

1. The document provides instructions for setting up a Digitizer device by navigating menus and configuring parameters according to a provided example. 2. Users are instructed to use cursor buttons to select the "SET UP" menu and then press additional buttons to configure 25 indicator lights to match a given parameter example. 3. The example parameter provided consists of binary values for settings like mode, format, baud rate, and parity that should be entered by turning indicator lights on or off according to whether the given value is a 1 or 0.

Uploaded by

Lucas Santos
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

1: Set up for Digitizer start the menu of Digitizer: For CD91200, put the cross of cursor to aim at the

SET UP pane of the menu, press the F, E buttons in order! 1.2 Press A repeatedly to set up the extinction or brightness situations for 25 pcs of little pane

The parameter is in below different software is different parameter below is just an example for Morgan software

MODE FORMAT RES BAUD PARITY LF ECHO


0000100 100010 000 100 1100 1 0

PLS. Note: 0 stands for the red indicator light in the relevant pane is off 1 stands for the red indicator light in the relevant pane is on The cross of cursor should aim at the center of each vertical pane, if the red indicator light is on, then it is 1, if the red indicator light is off, it is 0; Press the button A according to the requirement of parameter; you can change the situation of this pane. For example, if the old mode is 1, then the mode will be changed into 0 (Red light is off) after pressing the button A one time, and it will be 1 (Red light is on)after another pressing, you will change it in order to keep the mode is same as the requirement of parameter! When setting up is completed, put the cross of cursor to aim at the center of 1at the SAVE(Conservation District) in the menu, press button A of cursor, now the Digitizer make a buzz sound to notify that the setting up is completed, then it can be connected with software!

You might also like