Scribd
Upload
156 views2 pages

STR Assignment 1

This document contains a homework assignment for a Strength of Materials-II course. It includes 4 problems involving calculating shear and bending moments for beams under different loads, determining tensile and compressive stresses in a beam with two vertical forces, finding the maximum stress in aluminum and steel pipes securely bonded together under bending, and determining bending moments and residual stresses for a steel beam with a given elastic-plastic material property. Students are to submit their solutions to the teaching assistant by March 30, 2012.

Uploaded by

Yasin Delikucuk
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
156 views2 pages

STR Assignment 1

This document contains a homework assignment for a Strength of Materials-II course. It includes 4 problems involving calculating shear and bending moments for beams under different loads, determining tensile and compressive stresses in a beam with two vertical forces, finding the maximum stress in aluminum and steel pipes securely bonded together under bending, and determining bending moments and residual stresses for a steel beam with a given elastic-plastic material property. Students are to submit their solutions to the teaching assistant by March 30, 2012.

Uploaded by

Yasin Delikucuk
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Erciyes University Department of Mechanical Engineering Strength of Materials- II Homework No: 1

(12/ 03/ 2012)

1) Draw the shear and bending-moment diagrams for the beam and loading shown (Fig. 1.), and
determine the maximum absolute value (a) of the shear, (b) of the bending moment.

Fig. 1.

2) Two vertical forces are applied to a beam of the cross


section shown(Fig.2.). Determine the maximum tensile and compressive stresses in portion BC of the beam.

Fig. 2.

3) A steel pipe and an aluminum pipe are securely bonded together to form the composite beam
shown(Fig.3.). The modulus of elasticity is 200 GPa for the steel and 70 GPa for the aluminum. Knowing that the composite beam is bent by a couple of moment 500 N x m, determine the maximum stress (a) in the aluminum, (b) in the steel.

Fig.3.

4) A beam of the cross section shown (Fig.4.) is made of


a steel that is assumed to be elastoplastic with E= 200 GPa and y= 240 MPa. For bending about the z axis, determine the bending moment at which; (a) yield first occurs, (b) the plastic zones at the top and bottom of the bar are 30 mm thick. Fig.4. (c) a couple of moment equal to the full plastic moment Mp is applied and then removed. Determine the residual stress at y= 45 mm. (Draw stress distribution.)
Not: Bu dev , 30/ 03/ 2012 tarihine kadar Ar. Gr. Mehmet DRDNC'ye teslim edilecektir.

You might also like