Scribd
Upload
26 views3 pages

Epilog Win7 TCP

The document provides instructions for setting the TCP/IP address in Windows 7. It describes opening the Control Panel, navigating to Network and Sharing Center, selecting Change Adapter Settings, right clicking on Properties for the Local Area Connection, highlighting Internet Protocol Version 4 and clicking Properties. It then instructs to select "Use the following IP address", type in the IP address 192.168.3.3 and subnet mask 255.255.255.0, leave the default gateway blank, and click OK and Close to set the IP address.

Uploaded by

arudiver123
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
26 views3 pages

Epilog Win7 TCP

The document provides instructions for setting the TCP/IP address in Windows 7. It describes opening the Control Panel, navigating to Network and Sharing Center, selecting Change Adapter Settings, right clicking on Properties for the Local Area Connection, highlighting Internet Protocol Version 4 and clicking Properties. It then instructs to select "Use the following IP address", type in the IP address 192.168.3.3 and subnet mask 255.255.255.0, leave the default gateway blank, and click OK and Close to set the IP address.

Uploaded by

arudiver123
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Windows 7:

Setting up the TCP/IP Address in the Computer


Windows 7 uses a slightly different, but very similar protocol than previous versions of Windows to install the TCP/IP address in your computer. These instructions will guide you through the Windows 7 protocol. Once you have set the IP Address at the laser, you will need to set the TCP/IP address on your PC.

From the Start menu at the bottom left corner of your PC monitor, select Control Panel

Click on Network and Sharing Center

Click on Change adapter settings

Select the Local Area Connection option and then right click on Properties

Highlight Internet Protocol Version 4 (TCP/IP) and then click on Properties

Select Use the following IP address:

Type in the following IP Address and Subnet mask: 192.168.3.3 255.255.255.0

You can leave the Default gateway blank. This number is not an error; the last digit of the IP address in this window must be different than the IP address set in your laser system.

Click the OK button in this window and then click on the Close button in the next window. Thats it! The IP Address in your computer is set. Your computer will be able to talk to your laser after you install the print driver (which is the next step).

You might also like