Ride Through Solutions

Output power from 400 kVA up to 1250 kVA

Environmentally-Friendly Continuous Power

Power to rely on

Bridges short voltage interruptions Continuous Power Conditioning Up to 30 seconds Ride Through time Power Stabilization Battery Free solution Beneficial life cycle costs

People to rely on

Hitec Power Protection

For critical applications, a continuous, clean and uninterruptible power supply is a necessity. This is, for more than 50 years, the world of Hitec Power Protection. Our challenge is to provide customers worldwide with a solution for their power quality problems before any losses occur.

Hitec Power Protection has a proven track record of delivering high quality power solutions in demanding industries such as: Data centres Finance Aviation Process Healthcare Telecommunication Semiconductor

Features & Benefits Hitec Ride Through system

Fits industrys power quality system requirements Protects against disturbances, dips, spikes and short mains interruptions Filters utility borne harmonic voltages Filters load side borne harmonic currents Provides high short circuit output capacity Easy maintenance & operation Reliable due to use of long-time proven technology and components Simplicity of design; easy to operate and maintain No re-investment every 3-5 years for new batteries, no chemical waste! Long technical lifetime compared to systems with power electronics Beneficial cost of ownership Low system investment High energy efficiency Low maintenance cost Long economical lifetime High return of investment Easy installation Plug and play system Small footprint, reduced floor space requirements Requires modest environmental conditions No batteries means no dedicated climate control No special installation requirements such as exhaust and fuelling systems Easy to parallel Optional available as containerized system

A Hitec Ride Through system acts as a filter for all sorts of utility disturbances

Q3
1 3 6

Q1

Q2

4 2 5

1 2 3 4

Voltage peaks Frequency variations Brown-outs / voltage drops Mains interruptions

5 6 7

Radio frequency interferences Harmonic distortions Continuous quality power

Power to rely on

People to rely on

Rotary Ride Through system

Electrical power problems annually cost hundreds of billions in estimated lost data, material and productivity. Hitec Ride Through systems are developed to prevent downtime of your critical processes while keeping the investment low, saving you trouble and money. Hitec Ride Through systems bridge short interruptions in the utility supply, providing 15 seconds of Ride Through power at full load and up to 30 seconds at half load. The system easily bridges the gap between a power outage and the time required to switch to gen-set power. In addition it also operates as a continuous voltage conditioner whenever the utility or gen-set power is available. Total Cost of Ownership of a Ride Through solution is low and it is far more Environmentally-Friendly when compared to alternative power-electronic/ battery based systems. A Ride Through system is a profitable investment, especially in processes where the costs/risks of downtime are moderate.

Different Customers, Different Needs

At many locations the continuity and quality of the utility supply is very reliable, and as such power outages and voltage disturbances are not frequent and short. Nevertheless when they do occur, the business disruption and financial loss can be quite substantial. In many countries statistics show that more than 95% of power disturbances have duration of less than a few seconds. As such, 15-30 secondsof ride through time will greatly improve uptime performance by substantially reducing the number of process interruptions. A stand-alone Ride Through system in these cases is an adequate and justifiable investment. Hitec Power Protection Ride Through systems can easily be connected in parallel to support larger output powers. system for your downtime. In all applications the Ride quality and Through power avoids continuously provides For customers who already have sufficient back-up power from gen-sets, the Ride Through system is a cost-efficient complementary product that enables full Diesel-UPS functionality additional to the existing infrastructure. The Ride Through system will close the gap between a power outage and the required time to start up the gen-sets.

mission-critical

processes

Main Characteristics
In case of power outages the Ride Through system provides 15 - 30 seconds of Ride Through power. In utility and gen-set operation, the Ride Through system functions as an active harmonic filter, cleaning and regulating the output voltage to ensure that a smooth and constant sine wave is presented to the load. In addition it provides all the reactive power demand required by the load and so greatly improves the power factor requirement from the supply. In case of a short circuit of the utility or gen-set supply, the Ride Through system output voltage will be maintained regardless. Variations in the mains voltage will not influence the Ride Through output voltage. Whenever a short circuit occurs within the load distribution network,

Human Machine Interface

Hitec Ride Through systems have a control cabinet with an easy access touch screen. With this touch screen or HMI (Human Machine Interface) the systems performance can be monitored. Features: Full system history review for efficient support and service Several interface platforms including on-site and remote access are available to communicate with the Ride Through system

Customer Support
The Hitec Power Protection name is synonymous with reliability, quality and excellent service. We believe that the best technology is only as good as the service that supports it. We have therefore established a worldwide network of subsidiaries and qualified service partners. Our service can offer you: Customized maintenance solutions, in line with your needs and additional to your internal capacity Help Desk Services - available 24x7- for operational questions, remote monitoring, support, troubleshooting, etc. Remote monitoring and diagnostic support. Our service department can access your Ride Through system through the Internet or a modem connection and assist with operational issues, offer maintenance advice, provide troubleshooting, etc. Training programs at various skill levels for the operation and maintenance of your system.

UPS Rental Service

Hitec Rental Service offers containerized Ride Through units for unforeseen problems in your power supply, like temporary power problems, short to long time causes by maintenance works, capacity extensions, awaiting installation of a newly ordered system, etc. Of the system will produce sufficient fault curent to enable correct operation of the over-current protection devices. The Ride Through system improves power factor at its input and has an excellent efficiency. Quality is a must, so all Hitec Ride Through systems are factory tested prior to installation. Hitec Power Protection owns the worlds largest test field at its headquarters in Almelo, The Netherlands, for both 50 and 60 Hz applications up to 20MVA. With Ride Through you can rely on 50 years of proven technology. Our contact for UPS Rental Services Hitec Power Protection BV [email protected] Phone Fax : +31 546 589 589 : +31 546 589 489 course it is also an ideal solution to provide temporary cover whilst upgrade or maintenance works are being performed upon existing power supply infrastructures. Renting a containerized Ride Through system, with or without gen-sets, is an excellent way to validate that the Ride Through system offers a great solution to solve specific power problems.

RT 400
System power (load) [kVA] Active power (load) [kW] Power factor (load) Rated voltage [V] 400 320

RT 750
750 600

RT 1250
1250 1000 400/480 up to 24KV

RT Parallel
System power x units Active power x units

Between 0,8 inductive and 0,9 capacitive without derating

Input Data
Voltage Power factor Frequency Starting current 400V / 480V 10% 3 phase 4 wire 0,98 50/60 Hz 1,5 - 4 % (adjustable) 10% x I nom

Medium Voltage Hitec Ride Through System on request

Ride Through Output Ratings versus Ride Through Time

1500 1250 kVA

1250

Power (kVA)

1000 750 kVA

750

500

400 kVA

250

Time (sec)
0 0 5 10 15 20 25 30 35

Output Data
Ride through time Voltage (static) Voltage (dynamic) Recovery time Voltage THD Frequency Overload capacity Voltage symmetry Fault clearing capacity 15 sec. 100% load 30 sec. half load (longer time on request) 1% 5% 250 ms (50% load step) 1000 ms (100% load step) 3,5% (phase-phase with linear load) according to mains input frequency 1hr 110% ,10 min. 125%, 1 min. 150% (at mains operation) 120 1% > 10 x I nom

Dimensions
Weight (kg) Length (mm) Width (mm) Height (mm)

RT 400
8000 5230 1250 1460

RT 750
11000 5770 1250 1590

RT 1250
15000 6380 1580 1780

General Data
Flywheel speed all types Efficiency Cable entry Ambient temperature Altitude Degree of protection Classification max 2900 rpm up to 96% bottom entry (optional top entry) 0C 40 C max 3000 m without power de-rating IP21 G3 acc. to IEC 88528-11

Data for the containerised Ride Through systems or specific requirements at request.
All data in this brochure is for information and is subject to change without prior notice. No rights can be obtained form the contents of this brochure. Data provided in our offerings prevail at all times.

A global partner you can rely on

Hitec Power Protection has its worldwide headquarters and production & test facilities in Almelo, The Netherlands. Our Sales and service offices are in North America (Houston, Texas), the UK (Birmingham), Spain (Barcelona), China (Beijing), U.A.E. (Dubai), Singapore and Malaysia (Melaka). We maintain a regional support office in Taiwan, as well as numerous representatives and agents strategically placed throughout the world. Our efforts begin with a thought out technical recommendation targeted to your power quality and reliability need. If desired, we can take care of the complete electrical and mechanical installation and commissioning. Our commitment continues with training, instruction and maintenance. In case of emergency, our service organisation is 24x7 stand by to assist you with your needs.

Taiwan Hitec Power Protection Taiwan Ltd. 5F-1, No. 27, Puding Rd., Hsinchu 300 Taiwan Phone: +886 (03) 56 36 781 Fax: +886 (03) 56 37 135 e-mail: [email protected] web: www.hitec-ups.com The Netherlands Head office Hitec Power Protection bv Bedrijvenpark Twente 40 7602 KB Almelo The Netherlands Phone: +31 546 589 589 Fax: +31 546 589 489 e-mail: [email protected] web: www.hitec-ups.com United Kingdom Hitec Power Protection Ltd. Unit B21a Holly Farm Business Park Honiley, Kenilworth Warwickshire, CV8 1NP UK Phone: +44 1926 48 45 35 Fax: +44 1926 48 43 36 e-mail: [email protected] web: www.hitec-ups.com United States of America Hitec Power Protection Inc. 12502 Exchange Drive, Suite 404 Stafford, Texas 77477 USA Phone: +1 (281) 240 - 5335 Fax: +1 (281) 240 - 4774 e-mail: [email protected] web: www.hitecusa.com Spain Hitec Power Protection Ibrica S.L Pol. Ind. Moli den Serra C/Alt Penedes nave 4 43710 Santa Oliva (Tarragona) Spain Phone: +34 977 668 902 Fax: +34 977 157 334 e-mail: [email protected] web: www.hitec-ups.com China Hitec Power Protection Beijing Co. Ltd. D-1016 C, Building Top Box, No. 69 Bei Chen West Street Chaoyang District, Beijing 100029 China Phone: +86 10 58 77 20 36 Fax: +86 10 58 77 20 37 e-mail: [email protected] web: www.hitec-ups.com Singapore Hitec Power Protection BV Blk 3 Ang Mo Kio Industrial Park 2A #02-06 AMK Tech I Singapore 568050 Phone: +65 67 37 68 69 Fax: +65 67 37 68 70 e-mail: [email protected] web: www.hitec-ups.com Middle East & India Hitec Power Protection bv P.O. Box 50048 Dubai U.A.E. Phone: +971 434 737 00 Fax: +971 434 732 32 e-mail: [email protected] web: www.hitec-ups.com Malaysia Hitec Power Protection (Malaysia) SDN BHD TKT 3 Komplex MITC Jalan Konvensyen Ayer Keroh 75450 Melaka Malaysia Phone: +60 655 28 553 Fax: +60 655 28 563 e-mail: [email protected] web: www.hitec-ups.com