Scribd
Upload
32 views3 pages

Dac Manual

The document summarizes the objective of a digital-to-analog converter experiment which is to convert a digital input voltage to an equivalent analog output voltage. The procedure involves setting a reference voltage, applying a binary input via switches, measuring the analog output voltage with a multimeter, tabulating the results, and plotting graphs of the digital input versus analog output and digital input versus percentage output. The result is that the digital input is successfully converted to the corresponding analog output voltage.

Uploaded by

Dinesh Kumar Mehra
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
32 views3 pages

Dac Manual

The document summarizes the objective of a digital-to-analog converter experiment which is to convert a digital input voltage to an equivalent analog output voltage. The procedure involves setting a reference voltage, applying a binary input via switches, measuring the analog output voltage with a multimeter, tabulating the results, and plotting graphs of the digital input versus analog output and digital input versus percentage output. The result is that the digital input is successfully converted to the corresponding analog output voltage.

Uploaded by

Dinesh Kumar Mehra
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

D/A CONVERTER AIM To convert the given digital input into its equivalent analog output. OBJECTIVE 1. 2.

To study the conversion of binary voltage to analog o/p voltage To study the operation and characteristic of operational amplifier EQUIPMENT D-A trainer kit, multimeter CIRCUIT DIAGRAM:

S e le c t b in a ry c o d e

M e a s u re v o lta g e

S e t re fe n c e v o lta g e

PROCEDURE: i. ii. iii. iv. v. Make the connections as per the circuit diagram Apply the binary input by closing appropriate switches Measure the analog output using a multimeter. Tabulate the measured values. Plot a graph between digital input Vs analog output and digital input Vs % output. RESULT: Thus the given digital input is converted into its equivalent analog output.

You might also like