Scribd
Upload
68 views

Spring Load Calculation

The document provides specifications for designing a stainless steel spring including the wire diameter, modulus of rigidity, mean diameter, number of turns, number of springs, free length, operating length, spring rate, spring force, face area calculations, spring pressure, and notes that the spring pressure should be designed between 0.1 to 0.5 MPa. The spring design calculations meet this criteria with a spring pressure of 0.17 MPa.

Uploaded by

Gurujala Rajesh
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
68 views

Spring Load Calculation

The document provides specifications for designing a stainless steel spring including the wire diameter, modulus of rigidity, mean diameter, number of turns, number of springs, free length, operating length, spring rate, spring force, face area calculations, spring pressure, and notes that the spring pressure should be designed between 0.1 to 0.5 MPa. The spring design calculations meet this criteria with a spring pressure of 0.17 MPa.

Uploaded by

Gurujala Rajesh
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 1

Change only the details coloured yellow

Spring details: Wire Diameter of Spring, (d) Modulus of Rigidity for Stainless Steel Springs (G) Mean Diameter of the spring(D) No. of turns (n) No. of Springs(Ns) Free length(FL) Operating length(OL)
d=
5 2

0.60 mm

G= G = 0.79 x 10 N/mm 79000.00 N/mm2 ( Modulus of rigidity for stainless steel) D= 4.40 mm

n= Ns= FL= OL=

8.00 Dimensionless 9.00 Dimensionless 20.00 mm 11.00 mm ( OL must be more than the solid length ) Solid Length equals number of turns multiplied by wire diameter of the spring

Spring rate = Gd^4/(8D^3n) Spring Rate in kgf/mm


1.88 N/mm 0.19 Kgf/mm
(Since 1N =0.1019716 Kgf)

Spring Force ( Fs ) = Spring Rate* No.of Springs (Ns) *(FL OL)

15.51 kgf

Face Area Calculation


74.00 mm

Face ID
81.20 mm

Face OD Seal Face Area Seal face area in cm2 (Af) Spring Pressure ( Ps ) = Spring force(Fs)/ Face Area(Af) Spring pressure in Mpa
Spring Design 877.19 mm2 8.77 cm2 1.77 kgf/cm2 0.17 Mpa

DESIGN OK

( 1 Kgf/cm2=0.0980665 Mpa )

Note: The spring pressure on seal face should be designed for 0.1 to 0.5 Mpa.( 1 Kg/cm2 to 5 kg/cm2 )

You might also like