Scribd
Upload
25 views3 pages

Lesson 1 Exercises: Section 1

The document provides instructions for a SolidWorks lesson on creating an L-bracket part. The lesson has three sections: 1) Reviewing orientation views and creating a cross-sectional view of a provided L-bracket part. 2) Describing the features of the provided L-bracket part. 3) Creating a new L-bracket part by sketching the profile, extruding, adding fillets and holes using the Hole Wizard and extruded cuts. Dimensions and details are provided in a drawing.

Uploaded by

netomixc
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
25 views3 pages

Lesson 1 Exercises: Section 1

The document provides instructions for a SolidWorks lesson on creating an L-bracket part. The lesson has three sections: 1) Reviewing orientation views and creating a cross-sectional view of a provided L-bracket part. 2) Describing the features of the provided L-bracket part. 3) Creating a new L-bracket part by sketching the profile, extruding, adding fillets and holes using the Hole Wizard and extruded cuts. Dimensions and details are provided in a drawing.

Uploaded by

netomixc
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Lesson 1 Exercises

Section 1
Activity
Review all the different types of Orientation views and review how to move the part in the graphics area. Then create a cross-sectional view.

Instruction
1. Select the Orientation, Navigation and Sections view. a. Open the L-Bracket part provided. b. Go through each orientation view.

2. Move the part. a. Rotate b. Pan c. Roll View d. Zoom 3. Cross-sectional view a. b. c. d. e. Click Section View. Select the plane from the Section View Property Manager. Click and drag the arrow to the desired depth. Click OK. Click Section View once again to exit the Cross-sectional view.

Section 2
Activity
Describe each feature of L-Bracket part provided.

Instruction
1. Click a feature under Feature Manager Design Tree to highlight this feature on the model. www.SolidWorks.com/education Page 1 of 3

Section 3
Activity
Create an L-Bracket part. The details and dimensions are provided in the following drawing:

Instruction
1. 2. 3. 4. Create the L-shaped sketch on the right plane. Extrude the sketch into a 3D part. Add the Fillet feature by using Fillet Tool. Create two small holes by using the Hole Wizard. a. Click Hole Wizard under the Features tab on the Command Manager.

b. Under Hole Type, click the Hole icon. c. Under Hole Type, select ISO standard. d. Under Hole Type, select Drill Size as the type. e. Under Hole Specifications, select 6.0. f. Under End Condition, select Through All. www.SolidWorks.com/education

Page 2 of 3

g. Click the Positions tab on top of the property manager.

h. Place two holes on the bottom plate. i. Constrain them with the Smart Dimension tool. j. Click OK. 5. Create one large hole on the L-bracket using the Extruded Cut tool. 6. Remove the corners of the L-bracket by using Extruded Cut.

www.SolidWorks.com/education

Page 3 of 3

You might also like