Scribd
Upload
241 views

USBASP Programmer

USBasp is an open-source USB programmer for Atmel AVR controllers that uses an ATMega48 or ATMega8 microcontroller and passive components. It works on Linux, Mac OS X, and Windows without needing special USB controllers or drivers. Programming speeds can reach 5kBytes/sec and it supports targets with clock speeds below 1.5MHz. On Linux and MacOS X no driver is needed, but Windows requires downloading and installing a driver from the provided URL. Users connect it directly to their computer's USB port and follow installation wizard steps to set up the driver. The J1 jumper sets the programming speed as low for new chips and high for others, while the J2 jumper is used only if

Uploaded by

Deepak Reddy
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
241 views

USBASP Programmer

USBasp is an open-source USB programmer for Atmel AVR controllers that uses an ATMega48 or ATMega8 microcontroller and passive components. It works on Linux, Mac OS X, and Windows without needing special USB controllers or drivers. Programming speeds can reach 5kBytes/sec and it supports targets with clock speeds below 1.5MHz. On Linux and MacOS X no driver is needed, but Windows requires downloading and installing a driver from the provided URL. Users connect it directly to their computer's USB port and follow installation wizard steps to set up the driver. The J1 jumper sets the programming speed as low for new chips and high for others, while the J2 jumper is used only if

Uploaded by

Deepak Reddy
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

USBASP PROGRAMMER

Introduction
USBasp is an open-source USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega48 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver; no special USB controller is needed. AVRDUDE supports USBasp since version 5.2.

Features

Works under multiple platforms. Linux, Mac OS X and Windows XP/Vista (32 bit only) are tested. No special controllers or smd components are needed. Programming speed is up to 5kBytes/sec. SCK option to support targets with low clock speed (< 1.5MHz).

Drivers
On Linux and MacOS X no kernel driver is needed. Windows requires a driver for USBasp: which can be downloaded from http://www.fischl.de/usbasp/usbasp.2009-02-28.tar.gz

Steps for installing USBasp drivers


Connect USB cable to USBasp. Connect cable directly to USB port of computer avoiding Hubs. Wait for windows information New Hardware Found USBASP. If device is not detected, check the board for errors and reconnect again. After device is detected Driver setup wizard opens. Select where USBASP driver is located. It is in directory youve downloaded with firmware. If you unpacked in C: drive, than driver should be in C:\usbasp.2010-1229\bin\win-driver\ and press next. After successful setup, USBasp should appear in the device list in the device manager.

Jumper settings of USB programmer


The fuse bit settings of a brand new chip of AVR is configured such that the AVR can only be programmed at low speed. J1 Jumper is used to choose the speed of the programmer. SET J1 JUMPER for LOW SPEED. REMOVE J1 JUMPER for HIGH SPEED. Therefore, while programming a brand new AVR set J1 Jumper for programming at low speed. Also change the fuse bits of the new AVR such that it supports high speed programming. There is no need of J1 jumper for future

programming of the new AVR after following the previous step. J2 Jumper is used for burning the USBasp firmware into the chip. Dont use it unless required as it can damage the firmware in the USBasp.

You might also like