Scribd
Upload
2K views1 page

Código Sensor Presión Con Led 'If'

codigo arduino

Uploaded by

Angela Ampuero Arriagada
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

Código Sensor Presión Con Led 'If'

codigo arduino

Uploaded by

Angela Ampuero Arriagada
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

int

fsrAnalogPin = 0; // FSR is connected to analog 0 int LEDpin = 11; // connect Red LED to pin 11 (PWM pin) int fsrReading; // the analog reading from the FSR resistor divider int LEDbrightness; void setup(void) { Serial.begin(9600); // We'll send debugging information via the Serial monitor pinMode(LEDpin, OUTPUT); } void loop(void) { fsrReading = analogRead(fsrAnalogPin); Serial.print("Analog reading = "); Serial.println(fsrReading); // we'll need to change the range from the analog reading (0-1023) down to the range // used by analogWrite (0-255) with map! LEDbrightness = map(fsrReading, 0, 1023, 0, 255); // LED gets brighter the harder you press analogWrite(LEDpin, LEDbrightness); delay(1000); if(fsrReading > 986) { digitalWrite(LEDpin, LOW); } }

You might also like