Scribd
Upload
310 views1 page

PID Tuning Parameter Table

The document describes the parameters for PID controllers in Aim Historian and ExperTune software. It lists the parameters for the setpoint, process variable, controller output, and tuning values determined by each program, including proportional, integral, and derivative values from Aim Historian and gain, lag, lead, integration, and stability metrics from ExperTune.

Uploaded by

steam100deg1658
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
310 views1 page

PID Tuning Parameter Table

The document describes the parameters for PID controllers in Aim Historian and ExperTune software. It lists the parameters for the setpoint, process variable, controller output, and tuning values determined by each program, including proportional, integral, and derivative values from Aim Historian and gain, lag, lead, integration, and stability metrics from ExperTune.

Uploaded by

steam100deg1658
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PID Controller Tuning Parameter Table

Sr.No Loop ID Loop Description SPT

AIM Historian Parameter for PID controller


SPT Sample Time Meas Meas Sample Out Time OUT Sample SP Time PV CO Proportional Value(P) Integral Value(I)

ExperTune Parameter settings for PID Controller


Derivative Filter Value(I) Value(F) Fit Gain DT Lag1 Lag2 Lead Intg Stability RRT Units

Aim Historian Parameters: SPT Meas Out : Setpoint of PID Loop : Process Variable : PID Controller output

ExperTune Parameters: SP PV CO Fit Gain DT Lag1 Lag2 Lead Intg Stability Column RRT Units : Setpoint of PID Loop : Process Variable of Loop : PID Controller Output : Quality of frequency data fit : Process gain obtained by ExperTune : Process Dead time obtained by ExperTune : First Process Lag only if Process is modelled to have single or double lag : Second Process Lag only if Process is modelled to have double lag : Process Lead if the Loop is an inverse response process : If ExperTune Modeled process as integrating process,YES is shown : Relative Stability Index : Relative Response Time of loop with these Tuning Values : Units for models

You might also like