Scribd
Upload
2K views64 pages

Shaft Alignment Procedure

This training unit consists of a video tape presentation with an accompanying workbook. You will be directed an exercise after each video tape section, to the workbook where you complete (answer questions and do readings) this training program complete. The recommended (1) takes approximately two hours to sequence is as follows: gives the introductory remarks, after the student reads the objectives. The student should be able to: 1. Understand the difference between aligning couplings and aligning shafts.

Uploaded by

Paras Thakur
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views64 pages

Shaft Alignment Procedure

This training unit consists of a video tape presentation with an accompanying workbook. You will be directed an exercise after each video tape section, to the workbook where you complete (answer questions and do readings) this training program complete. The recommended (1) takes approximately two hours to sequence is as follows: gives the introductory remarks, after the student reads the objectives. The student should be able to: 1. Understand the difference between aligning couplings and aligning shafts.

Uploaded by

Paras Thakur
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 64

You might also like