Scribd
Upload
30 views3 pages

Microprocessor &amp Micro Controller Expt No.10

This document provides instructions for an experiment using a 8051 microcontroller kit. The experiment has three main objectives: 1) To load a program onto the microcontroller kit, 2) To execute the program, and 3) To check the results by viewing the contents of the registers. The procedure details the steps to load and run a program using the kit's assembler/disassembler and then view the register contents to check the results.

Uploaded by

महेश विजय खेडेकर
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
30 views3 pages

Microprocessor &amp Micro Controller Expt No.10

This document provides instructions for an experiment using a 8051 microcontroller kit. The experiment has three main objectives: 1) To load a program onto the microcontroller kit, 2) To execute the program, and 3) To check the results by viewing the contents of the registers. The procedure details the steps to load and run a program using the kit's assembler/disassembler and then view the register contents to check the results.

Uploaded by

महेश विजय खेडेकर
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

EXPERIMENT No. 10 1.

0 TITLE :
Introduction to microcontroller kit.

2.0 PRIOR CONCEPTS:


8051 Architecture .

3.0 NEW CONCEPTS:


1. Loading the program. 2. Executing the program. 3. Checking the results/contents of the registers.

4.0 LEARNING OBJECTIVES:


1. To load the program. 2. To execute the program. 3. To check the results/contents of the registers.

5.0 APPARATUS:
8051 Microcontroller Kit.
6.0

PROCEDURE & OBSERVATION TABLE :

I ] To load the program :


Sr. No 1 2 3 E ENTER Press Key Display ANSHUMAN EXPAND ? 8051 Line Assembler/Disassembler C= 4 A C=A

5 6 7

ENTER Q ENTER

C= C=Q Print off Command = ( Go to command mode)

[ II ] To execute the program :


Sr. No 1 2 3 4 5 Press Key G ENTER ENTER Given address 6000 ENTER Display GOTO BURST ADDR 6000 WAIT DONE

[ III ] To check the results/contents of the registers : 1 2 3 4 5 6 7 8


S ENTER Any Key ENTER ENTER ENTER ENTER ENTER SUBSTITUTE ? EXIT MEMORY REGISTER GENERAL NAME A= XX

NAME B = XX

NOTE: On pressing ENTER key each time , the contents of the registers will be
displayed in order.

You might also like