0% found this document useful (0 votes)
52 views1 page

LabS2 Basic Router Configuration

This document provides instructions for configuring basic settings on a router, including: 1. Configuring the router name, passwords for console/vty/enable, and encrypting passwords. 2. Configuring serial and FastEthernet interfaces, adding descriptions, and bringing interfaces up. 3. Configuring banners, IP addresses, host name resolution, and static routes. 4. Backing up configs and IOS to TFTP servers.
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
52 views1 page

LabS2 Basic Router Configuration

This document provides instructions for configuring basic settings on a router, including: 1. Configuring the router name, passwords for console/vty/enable, and encrypting passwords. 2. Configuring serial and FastEthernet interfaces, adding descriptions, and bringing interfaces up. 3. Configuring banners, IP addresses, host name resolution, and static routes. 4. Backing up configs and IOS to TFTP servers.
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

LabS2- Basic Router Configuration

RB 1 RA:+1 RB:+2 RC:+3 RD:+4 RE:+5 RF:+6 RA S0/0 2 S0/1 S0/0 F0/0 3 4 S0/1 F0/0 .12 S0/0 RC 5 6 S0/1 F0/0 S0/0 RD 7 8 S0/1 F0/0 S0/0 RE 9 10 S0/1 RF 11 172.16.X.0/24

F0/0

192.168.131.0/24 Rack-SW

Lab-SW

TFTP Server

Objectives:
In this lab, students configure some basic router settings: 1. Router name. 2. Router passwords:console, vty, enable password, perform password encryption. 3. Serial interfaces, FastEthernet interfaces. Routers(config)# interface f0/0 4. Interface description. no shutdown 5. Banners MOTD. ip address dhcp 6. Host name resolution. 7. Configure static routes. 8. Backing up configuration files, IOS on TFTP servers. 9. Capture the configuration by the Hyper Terminal 10. Verifying and Troubleshooting: show, telnet, ping, traceroute

You might also like