Scribd
Upload
31 views1 page

Polywrap Installation Guide

This document provides a step-by-step guide for installing polyethylene encasement on ductile iron pipe to prevent corrosion in corrosive environments. It describes removing debris from the pipe surface before installation and repairing any tears or holes in the polyethylene with tape. It also recommends using padded slings or cables to lift polywrapped pipe and sealing the ends of polyethylene tubes below the water table with tape or ties.

Uploaded by

Mohammad Yassine
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
31 views1 page

Polywrap Installation Guide

This document provides a step-by-step guide for installing polyethylene encasement on ductile iron pipe to prevent corrosion in corrosive environments. It describes removing debris from the pipe surface before installation and repairing any tears or holes in the polyethylene with tape. It also recommends using padded slings or cables to lift polywrapped pipe and sealing the ends of polyethylene tubes below the water table with tape or ties.

Uploaded by

Mohammad Yassine
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

A STEP-BY-STEP GUIDE FOR INSTALLING POLYETHYLENE ENCASEMENT ON DUCTILE IRON PIPE

Effective, Economical Protection for Ductile Iron Pipe In Corrosive Environments THIS POLYETHYLENE SLEEVE (polywrap) is placed on Ductile Iron pipe to prevent corrosion. It does not have to be sealed watertight, but it should be installed so that no dirt or bedding material comes in contact with the pipe. All lumps of clay, mud, cinders, etc., on the pipe surface should be removed before the pipe is covered with polyethylene. If the polyethylene is damaged, it must be repaired before the trench is backfilled. Small holes or tears can be repaired with a piece of tape placed over the hole. Large holes or tears should be repaired by taping another piece of polyethylene over the hole. Overlaps, ends, and repairs can be held in place with tape or plastic tie straps until the trench is backfilled. Other general tips for proper installation include: When lifting polywrapped pipe with a backhoe, use a fabric-type sling or padded cable to protect the polyethylene. When installing polywrap below the water table or in areas subject to tidal action, seal as thoroughly as possible both ends of each polyethylene tube with adhesive tape or plastic tie straps at the joint overlap. Also, place tape or plastic tie straps around the pipe at two (2) foot intervals. Quality of installation is more important than the actual sequence followed.

For More information, Please contact Northtown Company:

5202 Argosy Ave.,, Huntington Beach, CA 92649 Phone: 714-897-0700 - Fax: 714-897-0600
TOLL FREE: (800) 972-7274 Web Site: http://www.northtowncompany.com/polywrap.html

You might also like