Scribd
Upload
4K views

Node B Architecture NOKIA

1) The document describes the modular architecture of a Flexi WCDMA base transceiver station (BTS) which allows for flexible evolution from initial deployment to high-capacity solutions. 2) The Flexi WCDMA BTS consists of a system module equipped with a transmission sub-module and RF modules, including options for E1, T1, Ethernet, and SDH interfaces. 3) An optional additional system module can operate in a baseband extension mode to increase capacity.

Uploaded by

Sokhom Taing
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
4K views

Node B Architecture NOKIA

1) The document describes the modular architecture of a Flexi WCDMA base transceiver station (BTS) which allows for flexible evolution from initial deployment to high-capacity solutions. 2) The Flexi WCDMA BTS consists of a system module equipped with a transmission sub-module and RF modules, including options for E1, T1, Ethernet, and SDH interfaces. 3) An optional additional system module can operate in a baseband extension mode to increase capacity.

Uploaded by

Sokhom Taing
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

B) General Requirements 1) Flexi WCDMA BTS modular architecture enables flexible evolution from initial cost-effective roll-out coverage

BTS site up to a highcapacity BTS site solution. The modules are easy to install and move, and the modular structure allows the Flexi WCDMA BTS to be installed almost anywhere. Flexi WCDMA BTS ARCHITECTURE:

Figure 2: BTS architecture General Flexi WCDMA

Flexi WCDMA BTS consists of One System Module (FSMB, FSMC or FSMD), equipped with one of the following transmission sub-module alternatives and RF modules:

Figure2: Flexi WCDMA BTS modules E1/T1/JT1 transmission sub module (FTPB), or E1 (coaxial) transmission sub module (FTEB), or SDH STM-1/OC-3 transmission sub module (FTOA), or Flexbus transmission sub module (FTFA), or Hybrid E1/T1/JT1 and Ethernet transmission sub module (FTIA), or Hybrid E1 (coaxial) and Ethernet transmission sub module (FTJA), 16 E1/T1 interfaces transmission sub module (FTHA), Hybrid E1/T1/JT1 and Ethernet transmission sub module supporting Timing over Packet (FTIB), One optional System Module (FSMB, FSMC or FSMD) operating in baseband extension mode. Flexi BTS Multimode System Module (FSMD): Flexi BTS Multimode System Module is a high capacity System Module for high capacity sites, which can also be used as capacity expansion for Flexi System Module (FSMB).FSMD supports up to 500 CE HW (396 channel elements for traffic use).Common channels do not consume total CE capacity available for traffic use in most common configurations. Flexi BTS Multimode System Module is prepared for LTE evolution with SW upgrade. The System Module supplies the main baseband processing capacity for the WCDMA air interface. It hosts the Digital Signal Processing (DSP) processing software blocks. The System Module supports voice or data rates from 16 kbit/s up to 14.4 Mbit/s downlink with HSDPA

and HSUPA. Radio Modules: Nokia Siemens Networks provides radio modules. The Single and Dual RF Modules can be used in stack, pole or wall installations in indoor or outdoor. The Triple RF module provides equal installation options with highly integrated product. The Triple RF Module can support one, two or three sectors with the following features: Three Transceivers with TX for two carriers and RX for two carriers with diversity Three Linear Power Amplifiers FRGF with Triple 70 W 2100 Other frequency variants availability in planning phase Three RF filters for main and div branch A 48 V DC input power supply MHA and 3GPP Antenna tilt power feed and control for three sectors An interface to the BTS System Module RF Module chaining support Flexi Triple RF Module has three TX outputs that support a maximum of six TX carriers (2 carriers/TX chain). It has six dual carrier receivers that facilitate three dual carrier receivers with 2-way uplink diversity. One Triple RF Module can support, therefore, multiple configurations with flexible upgrade paths.

You might also like