Scribd
Upload
94 views1 page

Answer ALL Questions: Assignment 3

This document contains an assignment for an electrical engineering course. It asks students to define PROM, EPROM, and EEPROM, list characteristics of SRAM and DRAM, find specifications of a 27128 memory chip, draw its pin layout, and calculate addresses for different memory regions in a microprocessor system with EPROM, RAM, and I/O. Students are to answer questions about memory chip specifications and address calculations.

Uploaded by

Shell Ru Rendang Marang
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
94 views1 page

Answer ALL Questions: Assignment 3

This document contains an assignment for an electrical engineering course. It asks students to define PROM, EPROM, and EEPROM, list characteristics of SRAM and DRAM, find specifications of a 27128 memory chip, draw its pin layout, and calculate addresses for different memory regions in a microprocessor system with EPROM, RAM, and I/O. Students are to answer questions about memory chip specifications and address calculations.

Uploaded by

Shell Ru Rendang Marang
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DEPARTMENT OF ELECTRICAL ENGINEERING POLITEKNIK SULTAN MIZAN ABIDIN

ASSIGNMENT 3 Answer ALL questions a) Define the following terms: i. PROM ii. EPROM iii. EEPROM

(2 marks) (2 marks) (2 marks)

b) List THREE (3) characteristics of Static RAM and Dynamic RAM. (3 marks) c) Find the following for a memory chip with part number 27128. i. The capacity of memory chip in bits. (2 marks) ii. The size of memory chip in bytes. (2 marks) iii. The number of address lines. (2 marks) d) Draw the pins layout block diagram for the answer in question (c). (4 marks) e) A 16-bit microprocessor system was configured as below: - Starting address for 2 MB EPROM: 000000H - End address for 6 MB RAM: 9FFFFFH - Starting address for 1 MB I/O: A00000H i. Calculate the end address of EEPROM ii. Calculate the starting address of RAM iii. Calculate the end address of I/O (2 marks) (2 marks) (2 marks)

[email protected]

JKE, PSMZA

You might also like