Scribd
Upload
158 views1 page

Center Lines

To create centerlines in a drawing view: 1. Open the drawing file and switch to the Drawing Annotation panel. 2. Select "Centerline" from the center mark flyout menu. 3. Click to select the starting center point, then the ending center point. 4. Right click and select "Create" to generate the centerline between the points.

Uploaded by

api-3714448
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
158 views1 page

Center Lines

To create centerlines in a drawing view: 1. Open the drawing file and switch to the Drawing Annotation panel. 2. Select "Centerline" from the center mark flyout menu. 3. Click to select the starting center point, then the ending center point. 4. Right click and select "Create" to generate the centerline between the points.

Uploaded by

api-3714448
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Creating Centerlines in the Drawing Views

1. Open the drawing (idw) file in which the centerlines are to be created.
2. Right-click in the Drawing Views Panel panel bar in the drawing mode
and choose the Drawing Annotation Panel option. The Drawing
Annotation Panel panel bar will be displayed in place of the Drawing
Views Panel panel bar.
3. Choose the down arrow on the right of the Center Mark option and from
the flyout that appears, choose Centerline.
4. You will be prompted to click on a location. Move the cursor close to the
first center point of the hole from where you want the center line to start.
The cursor automatically snaps on to that point and turns green in color.
Select the point when the cursor turns green, see Figure 1.

5. Next, move the cursor to the second center point of the hole and when the
cursor snaps to the center point, select the point. See Figure 2.

6. Now, right-click and choose Create from the shortcut menu. The
centerline will be created, see Figure 3.

Similarly, you can add as many centerlines as you want in the drawing views.

You might also like