Material: Safety Data Sheet
Material: Safety Data Sheet
Material: Safety Data Sheet
DATA SHEET PAINT MASTER SLURRY 1 PRODUCT IDENTIFICATION AND COMPANY NAME : : : : Paint Master Slurry Acrylic Cement Modifier Martin Vosloo Paints Unit 6 Bernie Industrial Estate Kaya Sands
COMPOSITION/INFORMATION ON INGREDIENTS : : Acrylic resin emulsion Acrylic resin and small amounts of organic solvents-this product is not classed as hazardous but should carry the following S Phrases S2, S24/25
HAZARDS IDENTIFICATION : This paint is NOT flammable : Respiration : May cause irritation. Eyes : May cause slight irritation. Ingestion : May cause gastro-intestinal irritation. Skin : In General no irritation : Toxic to aquatic organisms. May cause long-term adverse effects in the aquatic environment.
General Inhalation
: In all cases of doubt, or when symptoms persist, seek medical attention. Never give anything by mouth to an unconscious person. : Move to a safe area with fresh air. Keep person warm and at rest. If not breathing, if breathing is irregular or if respiratory arrest occurs, provide artificial respiration or oxygen by trained personnel. Give nothing by mouth. If unconscious, place in recovery position and seek medical advice. : Rinse thoroughly with water for at least 10 minutes. Seek medical attention. : Do not induce vomiting. Keep person warm and at rest. Seek medical advice immediately and show the container or label. : Remove contaminated clothing and shoes. Wash skin thoroughly with soap and water or use a recognized skin cleanser. Do not use solvents or thinners.
FIRE-FIGHTING MEASURES
This paint is NOT flammable but the dry residue is combustible Expect no direct explosion hazard
HANDLING AND STORAGE : Keep container tightly closed. Eating, drinking and smoking should be Issue 1 dated June 11 Page 1 of 3
Storage
EXPOSURE CONTROL/PERSONAL PROTECTION : Provide adequate ventilation. Where reasonably practicable this
should be achieved by the use of local exhaust ventilation and good general extraction. If these are not sufficient to maintain concentrations of particulates and solvent vapour below the OEL, suitable respiratory protection must be worn.
Engineering Measures
Personal Protective Equipment Respiration Eyes Ingestion Skin Environmental Exposure Control 9
STABLILTY AND REACTIVITY : Stable under recommended storage and handling conditions. : Excessive heat store below 30 degrees Celsius : Oxidizing agents, strong alkaline or acidic materials.
TOXICOLOGICAL INFORMATION
Frequent and prolonged skin contact may cause irritation and skin inflammation. Prolonged inhalation of vapours in high concentrations may lead to headache, giddiness and nausea. In case of contact with the product, irritation of the skin/mucous membranes.
12
ECOLOGICAL INFORMATION
There is no data available on the preparation itself. Product is considered a water pollutant. Do not allow to enter drains or watercourses.
13
DISPOSAL CONSIDERATIONS
Do not allow to enter drains or watercourses. Dispose according to state and local applicable regulations. Empty containers are suitable for recycling.
14
TRANSPORT INFORMATION
Page 2 of 3
Keep out of reach of Children Avoid contact with eyes and skin
OTHER INFORMATION : : : : June 11 June 11 1 The information in this MSDS is based on the present state of our knowledge and on current national laws. The product is not to be used for purposes other than those specified under section 1 without first obtaining written handling instructions. It is always the responsibility of the user to take all necessary steps in order to fulfill the demand laid down in the local rules and legislation. The information in this MSDS is meant as a description of the safety requirements of our product it is not to be considered as a guarantee of the products properties.
Page 3 of 3