Scribd
Upload
18 views

Configuring The Netweaver System

1. The document provides steps to configure a NetWeaver system including logging into SAP, running a preparation check procedure, checking for issues, and executing an add-on implementation procedure. 2. It also outlines steps to configure the SDCCN transaction including accessing utilities to activate it and confirming several prompts. 3. Additionally, it details configuring a connection to a Solution Manager system by adding an RFC destination, selecting the Solution Manager system, and confirming prompts.

Uploaded by

murali_22
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
18 views

Configuring The Netweaver System

1. The document provides steps to configure a NetWeaver system including logging into SAP, running a preparation check procedure, checking for issues, and executing an add-on implementation procedure. 2. It also outlines steps to configure the SDCCN transaction including accessing utilities to activate it and confirming several prompts. 3. Additionally, it details configuring a connection to a Solution Manager system by adding an RFC destination, selecting the Solution Manager system, and confirming prompts.

Uploaded by

murali_22
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 14

1. Configuring the NetWeaver system.

a. Log into the SAP system. b. Go into SE38 for the Preparation Check procedure. c. In the program field = RTCCTOOL d. Then hit Execute button. The following screen will be shown:

Depending on your current location you should need to select the corresponding nearest SAPSERV system, then leave the defaults values and click ( The following screen should appear: ) button.

You will need to check every Red status item and read the associated OSS note to correct the issue first. e. Then hit Addons&Upgr button.

f. Execute Procedure after add-on implementation button, only in case of the Red cross. The following screen should appear next:

Depending on your current version, the comment information shown above could be different. g. Hit the ( ) check.

The next screen should only have green checks now:

2. Configuring transaction SDCCN.

a. Call transaction SDCCN. b. Choose from the menu Utilities --> Activate

c. Confirm with Yes.

d. Confirm with Yes.

e. Confirm with Yes.

f. Confirm with (

).

g. Confirm with (

).

h. Confirm with (

).

Now, the following screen should appear:

Click Back button.

3. Configuring connection to Solution Manager.


a. From the menu select Go To --> Settings --> Task-specific. The following screen should appear:

b. Highlight RFC Destinations --> Settings. c. Click on the square/table next to Settings.

d. Switch to Change mode. e. Click Add RFC Destination button. f. Enter a description like My Solution Manager Destination.

g. Open the matchcode or press F4 in Destination field. h. Choose your Solution Manager RFC destination. Note: This destination should already exist or must be configured manually through transaction SM59.

Example:

i. Hit (

) check.

j. Select the Solution Manager destination recently created. k. Click Set Master SAP Solution Manager System button. l. Check Destination field and select Solution_Manager from the matchcode.

m. Hit (

) check twice.

n. Confirm with Yes.

o. Hit Back. p. Hit Refresh button.

4. Starting first Service Preparation Check.


a. Highlight Service Preparation check. Then Edit --> start now.

b. Confirm with Yes.

c. Confirm with Yes.

d. Confirm with Back button.

e. Confirm with Yes. The following screen will be shown:

Congratulation, you have successfully activated the new SDCC transaction and configured the EWA connection to your Solution Manager system.

You might also like