0% found this document useful (0 votes)
87 views22 pages

CC CC

This document provides an overview of the evolution of cellular network technologies leading up to 4G networks, focusing on 3GPP LTE and LTE-Advanced. It describes the key technologies enabling LTE, including OFDM, MIMO, and beamforming. Requirements for LTE include high peak data rates, mobility support, and spectrum flexibility. LTE-Advanced proposes enhancements such as improved MIMO techniques, coordinated multi-site transmission, and relays to achieve the goals of 1Gbps peak rates and 30bps/Hz peak spectrum efficiency.

Uploaded by

Zezo Alex
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
87 views22 pages

CC CC

This document provides an overview of the evolution of cellular network technologies leading up to 4G networks, focusing on 3GPP LTE and LTE-Advanced. It describes the key technologies enabling LTE, including OFDM, MIMO, and beamforming. Requirements for LTE include high peak data rates, mobility support, and spectrum flexibility. LTE-Advanced proposes enhancements such as improved MIMO techniques, coordinated multi-site transmission, and relays to achieve the goals of 1Gbps peak rates and 30bps/Hz peak spectrum efficiency.

Uploaded by

Zezo Alex
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 22

LTE and LTE-Advanced: An Introduction

Karim Seddik
Alexandria University Nile University
April 16, 2011

The history
 1G (Early 1980s)
Analog speech communications. Ex: AMPS

 2G (Early 1990s)
Digital modulation of speech communications. Advanced security and roaming. TDMA and narrowband CDMA. Ex: GSM

 3G (Late 1990s)
Global harmonization and roaming. Wideband CDMA Ex: UMTS

Beyond 3G
 Evolutionary path beyond 3G
Mobile class targets 100 Mbps with high mobility Local area class targets 1 Gbps with low mobility

 3GPP is currently developing evolutionary/ revolutionary systems beyond 3G


3GPP Long Term Evolution (LTE)

 IEEE 802.16-based WiMAX is also evolving towards 4G through 802.16m

3GPP Evolution
    Release 99 (Mar. 2000): UMTS/WCDMA Rel-5 (Mar. 2002): HSDPA Rel-6 (Mar. 2005): HSUPA Rel-7 (2007): DL MIMO, optimized real-time services (VoIP, gaming, )  Long Term Evolution (LTE)
3GPP work on the Evolution of the 3G Mobile System started in November 2004. Standardized in the form of Rel-8. Spec finalized and approved in January 2008.

 LTE-Advanced study phase in progress.

Requirements for LTE


 Peak data rate
100 Mbps DL/ 50 Mbps UL within 20 MHz bandwidth. Up to 200 active users in a cell (5 MHz) Less than 5 ms user-plane latency

 Mobility
Optimized for 0 ~ 15 km/h. 15 ~ 120 km/h supported with high performance. Supported up to 350 km/h or even up to 500 km/h.

 Spectrum flexibility: 1.25 ~ 20 MHz  Enhanced support for end-to-end QoS

LTE Enabling Technologies



Two main technologies
1. Orthogonal Frequency Division Multiplexing (OFDM) 2. Multiple-Input Multiple-Output (MIMO)

OFDM: A bandwidth efficient technique

QuickTime and a decompressor are needed to see this picture.

OFDM (continue)
 Multi-carrier transmission offers various advantages over traditional single carrier approaches  Highly scalable  Simplified equalizer design in the frequency domain, also in cases of large delay spread  High spectrum density  Simplifies the usage of MIMO  Good granularity to control user data rates  Robustness against timing errors

Multiple-Input Multiple-Output (MIMO)


 Future wireless services require high data rates and high signal quality  The wireless resources such as the bandwidth are scarce  Wireless channels have a lot of impairments such as fading, shadowing, and multiuser interference  One solution is the use of Diversity achieving schemes  Spatial diversity is of special interest!

MIMO (continue)

QuickTi c r ss r t s t is ictur .

Goals of LTE

QuickTi c r ss r t s t is ictur .

MIMO Techniques
1.

Spatial Multiplexing
Goal is to maximize data rate Send as much independent data as possible over different antennas Works only if number of receiver antennas is greater or equal to number of transmit antennas(i.e. less suitable for DL)

2.

Space-Time Coding
Goal is to enhance the signal quality Achieves spatial diversity by introducing redundancy Alamouti Scheme is the most popular STC (for a 2xN system)

MU-MIMO - Space-Division Multiple Access (SDMA)

Qui

i i i ure.

Multi-User MIMO (MU-MIMO)

ar n

Q ickTim and a d compr ssor d d to s this pict r .

Downlink (DL) Beamforming

QuickTime and a decompressor are needed to see this picture.

Requirements for LTE-Advanced (LTE-A)


 LTE-A shall have same or better performance than LTE  Peak data rate (peak spectrum efficiency)
 Downlink: 1 Gbps, Uplink: 500 Mbps

 

Peak spectrum efficiency


 Downlink: 30 bps/Hz, Uplink: 15 bps/Hz

Same requirements as LTE for mobility, coverage, synchronization, spectrum flexibility etc

LTE-A Proposed Enhancements

ar n

Q ickTim and a d compr ssor d d to s this pict r .

LTE-A Technology Proposals


 MIMO enhancements  Cooperative multi-site transmission  Repeaters and relays

MIMO Enhancements for LTE-A

QuickTime and a decompressor are needed to see this picture.

Coordinated Multi-Point Transmission (CoMP)

QuickTime and a decompressor are needed to see this picture.

QuickTime and a decompressor are needed to see this picture.

Relaying

QuickTi c r ss r t s t is ictur .

You might also like