Scribd
Upload
59 views1 page

Ont Page Priantable Ok

This dissertation submitted by Srikumar Biradar to Sardar Vallabhbhai National Institute of Technology, Surat analyzes tool-chip interface friction in orthogonal metal cutting using finite element method. The study is conducted under the guidance of Dr. D. I. Lalwani in partial fulfillment of the requirements for a Master of Technology degree in Industrial Process Equipment Design.

Uploaded by

Shree Biradar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views1 page

Ont Page Priantable Ok

This dissertation submitted by Srikumar Biradar to Sardar Vallabhbhai National Institute of Technology, Surat analyzes tool-chip interface friction in orthogonal metal cutting using finite element method. The study is conducted under the guidance of Dr. D. I. Lalwani in partial fulfillment of the requirements for a Master of Technology degree in Industrial Process Equipment Design.

Uploaded by

Shree Biradar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

A DISSERTATION ENTITLED

STUDY AND ANALYSIS OF TOOL-CHIP INTERFACE FRICTION IN ORTHOGONAL METAL CUTTING BY FINITE ELEMENT METHOD
SUBMITTED TO SARDAR VALLABHBHAI NATIONAL INSTITUTE OF TECHNOLOGY SURAT IN PARTIAL FULFILLMENT OF THE REQUIREMENT FOR THE DEGREE OF

MASTER OF TECHNOLOGY
IN

INDUSTRIAL PROCESS EQUIPMENT DESIGN


(MECHANICAL ENGINEERING DEPARTMENT)
SUBMITTED BY

SRIKUMAR BIRADAR (P09IP707)


GUIDED BY

Dr. D. I. LALWANI Asst. Prof. (MECHANICAL ENGG. DEPT)

2010-2011
DEPARTMENT OF MECHANICAL ENGINEERING SARDAR VALLABHBHAI NATIONAL INSTITUTE OF TECHNOLOGY, SURAT-395007, GUJARAT, INDIA

You might also like