50% found this document useful (2 votes)
266 views11 pages

Frequency Polygon

Frequency polygons are a graphical device for understanding the shapes of distributions. They serve the same purpose as histograms, but are especially helpful in comparing data. To create a frequency polygon, start by choosing a class interval. Mark the middle of each class interval with a tick mark and label it with the middle value.

Uploaded by

HACNAH
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
50% found this document useful (2 votes)
266 views11 pages

Frequency Polygon

Frequency polygons are a graphical device for understanding the shapes of distributions. They serve the same purpose as histograms, but are especially helpful in comparing data. To create a frequency polygon, start by choosing a class interval. Mark the middle of each class interval with a tick mark and label it with the middle value.

Uploaded by

HACNAH
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 11

Frequency polygons are a graphical device for understanding the shapes of distributions.

They serve the same purpose as histograms, but are especially helpful in comparing sets of data. Frequency polygons are also a good choice for displaying cumulative frequency distributions.

To create a frequency polygon, start just as for histograms, by choosing a class interval. Then draw an X-axis representing the values of the scores in your data. Mark the middle of each class interval with a tick mark, and label it with the middle value represented by the class. Draw the Y-axis to indicate the frequency of each class.

Place a point in the middle of each class interval at the height corresponding to its frequency. Finally, connect the points. You should include one class interval below the lowest value in your data and one above the highest value. The graph will then touch the X-axis on both sides

You might also like