Scribd
Upload
23 views

Embedded

The document is an exam for an embedded systems course containing two parts. Part A has 10 multiple choice questions worth 2 marks each about embedded systems topics like definitions, design process steps, addressing modes, and I/O devices. Part B has 3 longer answer questions worth 10 marks each about embedded system design process, challenges in design, and interrupts or I/O devices. The exam is worth a total of 50 marks and must be completed in 1 hour and 30 minutes.

Uploaded by

Karthigha Sekar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
23 views

Embedded

The document is an exam for an embedded systems course containing two parts. Part A has 10 multiple choice questions worth 2 marks each about embedded systems topics like definitions, design process steps, addressing modes, and I/O devices. Part B has 3 longer answer questions worth 10 marks each about embedded system design process, challenges in design, and interrupts or I/O devices. The exam is worth a total of 50 marks and must be completed in 1 hour and 30 minutes.

Uploaded by

Karthigha Sekar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

KAMBAN ENGINEERING COLLEGE

VELU NAGAR , TIRUVANNAMALAI. Department Of Information Technology IT2354- EMBEDDED SYSTEMS Date: .01.2011 Sem/Year: VI/III (A&B) Marks:50 Time:1.30min

PART A

(10*2=20)

1. Define Embedded Systems? 2. What are the important problems considered while designing the system? 3. What are the two objectives of Embedded System design process? 4. Draw the Major steps in Embedded system design process? 5. Define Little endian and Big endian? 6. What is CPSR? 7. Explain Base Plus-Offset addressing and its types? 8.Write the program for y=a*(b+c) . 9. What are the types of register used in typical I/O device? 10. Define polling?

PART B
11.Write in detail about the Embedded System Design Process 12.(a)(i)Explain the Challenges while designing Embedded System. (ii)Give the types of requirements. Or 12.(b)Define ARM processor with its instruction sets. 13.(a) Explain about the I/O devices, primitives and Busy-Wait I/O. Or 13.(b) Discuss in detail about the interrupts in embedded system

(3*10=30)
(10) (8) (5)

(10) (10)

(10)

Prepared by Verified by

S.KARTHIGHA(Lect/ECE) S.A.SAMSON(HOD/ECE)

You might also like