Scribd
Upload
48 views2 pages

IC - 4 Sem Micro Controller Lab

4th Sem Diploma in Electronic Instrumentation and control

Uploaded by

Vikram Rao
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
48 views2 pages

IC - 4 Sem Micro Controller Lab

4th Sem Diploma in Electronic Instrumentation and control

Uploaded by

Vikram Rao
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Department of Technical Education Diploma course in Electronic Instrumentation and Control Engineering Fourth semester Subject IC 405: Microcontroller

Lab Contact Hours / week: 6 Contact hours / sem: 96 hours Graded exercises Section A Write and execute the following 8051 programs 1) Program to ADD two 8 bit signed and Unsigned numbers 2) Program to ADD series of N, 8 bit numbers 3) Program to ADD two Multibyte numbers 4) Program to convert two digit Packed BCD to Unpacked BCD 5) Program to convert Unpacked BCD to two digit Packed BCD 6) Program to convert two digit BCD to Gray code 7) Program to convert two digit BCD to excess 3 code 8) Program to convert two digit BCD to ASCII code 9) Program to convert ASCII to two digit BCD code 10) Program to perform two 8 bit multiplication 11) Program to perform two 8 bit Division 12) Program to separate positive and negative numbers in a series of N bytes 13) Program to count number of ones and zeros in an 8 bit data 14) Program to find the smallest number in a series of N byte 15) Program to find the largest number in a series of N byte 16) Program to generate a specific time delay 17) Program to find factorial of a number ( less than 5) 18) Program to arrange a series of numbers in ascending order No of Hours 60

19) Program to arrange a series of numbers in descending order 20) Program to search a specified number in a given array of numbers Section B (Any five) 1) Program to Interface LED & Switch 2) Program to Interface a seven segment display 3) Program to interface 4 x 4 keypad 4) Program to count the number of times a key is being pressed and to display the count 5) Program to generate four different buzzer sounds when corresponding key is pressed 6) Program to generate moving light display using at least 8 LEDs 7) Program to interface traffic light control 8) Program to Interface stepper motor Tests and Assignment Note: The student must draw the flowchart for all the programs The student must write & execute all the programs from section A The student can do any five interfacing programs from section B Mini Project A competency based approach to build an application Scheme of Valuation Sl no. 1 2 3 4 5 Particulars Lab record Writing two program Entering and Execution(one program) Result / Print out Viva voce Total Marks 05 30 35 10 20 100 6 Hours 30 Hours

You might also like