Scribd
Upload
232 views2 pages

Triangular

The document describes how to build and test triangular and square wave generators using a 741 opamp. It lists the required components including a CRO, resistors, signal generator, oscilloscope probes, 741 opamp, capacitors, and multimeters. The design equations for the triangular wave amplitude and frequency are given. The procedure involves wiring the circuit, varying a 1K potentiometer to obtain the maximum output voltage, and applying a DC voltage to vary the square/triangular pulse width. Plots of the first and second stage outputs are to be recorded.

Uploaded by

Avinash Nandakumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
232 views2 pages

Triangular

The document describes how to build and test triangular and square wave generators using a 741 opamp. It lists the required components including a CRO, resistors, signal generator, oscilloscope probes, 741 opamp, capacitors, and multimeters. The design equations for the triangular wave amplitude and frequency are given. The procedure involves wiring the circuit, varying a 1K potentiometer to obtain the maximum output voltage, and applying a DC voltage to vary the square/triangular pulse width. Plots of the first and second stage outputs are to be recorded.

Uploaded by

Avinash Nandakumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd

08.

408 Analog Integrated circuits Lab Manual Triangular wave generator and square wave generator using 741 opamp Aim: To test and generate a triangular wave generator and square wave generator using 741 opamp Components required : CRO (20Mhz ,dual channel) Resistors Signal generator Oscilloscope probes ua741 opamp, capacitors,multimeters

Design : Vtrp-p=2 R1/R2.Vsat fo=R2/4R1R3C1 f0'=fo(1-(Vref/Vsat)2) duty cycle T1/T=0.5(1-Vref/Vsat) Procedure :a)Wire up the circuit as in circuit b) Vary the 1K ohm pot to get maximum voltage output of the wave form (triangle or square). c) Apply a dc voltage to the non- inverting terminal of the second stage to vary the pulse Dept of ECE,VKCET

08.408 Analog Integrated circuits Lab Manual width of the square/triangular pulse. d) Plot the output of the first and second stages and record the result Result: The Vpp of the triangular wave and square wave generator using opamp is ..V and ..V The fo of the triangular wave is ...Hz and the duty cycle is = ..

Dept of ECE,VKCET

You might also like