Scribd
Upload
55 views3 pages

Oscillators

This document provides instructions for an electronics lab experiment involving two oscillator circuits using an op-amp. Students are asked to build a Wien bridge oscillator and RC phase shift oscillator on a breadboard. For each circuit, they will adjust components to start oscillations, control the amplitude, and record the output frequency and voltage. The goal is to plot the output waves and verify the functioning of the two common oscillator designs.

Uploaded by

Avinash Nandakumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
55 views3 pages

Oscillators

This document provides instructions for an electronics lab experiment involving two oscillator circuits using an op-amp. Students are asked to build a Wien bridge oscillator and RC phase shift oscillator on a breadboard. For each circuit, they will adjust components to start oscillations, control the amplitude, and record the output frequency and voltage. The goal is to plot the output waves and verify the functioning of the two common oscillator designs.

Uploaded by

Avinash Nandakumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

08.

408 Analog Integrated circuits Lab Manual Wien Bridge Oscillator using Opamp Aim : To plot the output and verify the working of a Wien bridge oscillator using 741 opamp using amplitude stabilization and amplitude control Components required : CRO (20Mhz ,dual channel) Resistors Signal generator Oscilloscope probes ua741 opamp, capacitors,multimeters

Design Av=3

foscillations = 1/ 2 RC

Procedure Dept of ECE,VKCET

08.408 Analog Integrated circuits Lab Manual a) Wire up the circuit in breadboard as in figure. Also connect amplitude stabilization circuit b) Power up circuit and adjust R1 pot so that sustained oscillations are available. c) In order to adjust amplitude vary the output voltage using a 10K ohm pot d) Record the result and output graph

Result: Sine wave Wien Bridge Oscillator f= ... Khz ,Vo= ........V

RC phase shift Oscillator using opamp Aim : To plot the output and verify the working of a RC phase shift Oscillator using 741 opamp Components required : CRO (20Mhz ,dual channel) Resistors Signal generator Oscilloscope probes ua741 opamp, capacitors,multimeters

Design:
Dept of ECE,VKCET

08.408 Analog Integrated circuits Lab Manual

foscillations = 1/ 2 6 RC Rf=29 R1
Procedure a) Wire up the circuit in breadboard as in figure. Also connect amplitude stabilization circuit b) Power up circuit and adjust R1 pot so that sustained oscillations are available. c) In order to adjust amplitude vary the output voltage using a 10K ohm pot d) Record the result and output graph

Result: Sine wave Wien Bridge Oscillator f= ... Khz ,Vo= ........V

Dept of ECE,VKCET

You might also like