Scribd
Upload
34 views2 pages

Installation Guide: MS7320 Flex Stand Kit Components

This document provides instructions for installing the MS7320 Flex Stand. It includes a list of kit components and notes that flex pole length and number of flex covers varies by kit number. The installation instructions involve drilling holes in the counter top, securing the stand base and attaching the flex pole assembly, sliding flex covers over the pole, removing the scanner's cable cover, releasing and removing the scanner's pedestal, attaching the pedestal to the flex pole, sliding the scanner onto the pedestal until it locks into place, connecting cables before replacing the cable cover, and installing the cable cover.

Uploaded by

Eduardo Ceroni Navarro
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views2 pages

Installation Guide: MS7320 Flex Stand Kit Components

This document provides instructions for installing the MS7320 Flex Stand. It includes a list of kit components and notes that flex pole length and number of flex covers varies by kit number. The installation instructions involve drilling holes in the counter top, securing the stand base and attaching the flex pole assembly, sliding flex covers over the pole, removing the scanner's cable cover, releasing and removing the scanner's pedestal, attaching the pedestal to the flex pole, sliding the scanner onto the pedestal until it locks into place, connecting cables before replacing the cable cover, and installing the cable cover.

Uploaded by

Eduardo Ceroni Navarro
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Installation Guide

May 2005

MS7320 Flex Stand


00 - 02066B
Kit Components

a. Stand Base Cover .............................................. Qty. 1


b. Stand Base ......................................................... Qty. 1
c. Small Flex Cover * ............................................. Qty. 1
d. Flex Pole * ......................................................... Qty. 1
e. Large Flex Cover *.............................................. Qty. 1
f. #8 x 1.00" Wood Screw ...................................... Qty. 4
g. ¼"-20 x ¾" Flat Head Screw .............................. Qty. 1
h. ¼" External Lock Washer ................................... Qty. 2
i. ¼" Flat Washer .................................................. Qty. 1

* Flex pole length and flex cover quantities are kit dependent.

Flex Pole Flex Cover Qty.


Kit Number
Length (d.) Small (c.) Large (e.)
46-00174 3" 1 Not Applicable
46-00157
6" 1 1
46-00173
46-00175 12" 2 1

Installation

1. Drill four #39 pilot holes in the counter top for the
stand base.

2. Secure the base plate and attach the flex pole


assembly.

3. Slide the flex covers over the flex pole assembly.


4. Remove the scanner’s cable cover if necessary.

5. Pull the tab on the scanner’s pedestal to release the


lock. Slide the pedestal off the scanner.

6. Attach the scanner pedestal to the flex pole.

7. Slide the scanner onto the pedestal until it clicks


locking the scanner to the stand.

8. Before installing the scanner’s cable cover, refer to


the Installation and User’s Guide (MLPN 00-02896x)
for instructions on the proper cable connections.

9. Install the scanner’s cable cover.

You might also like