Scribd
Upload
639 views

Functional

The Functional Reach Test is a single-item test used to screen older adults for balance problems and fall risk. A score of 6 inches or less indicates a high risk of falls, while a score between 6-10 inches indicates a moderate risk. The test involves having a patient stand next to a wall with a yardstick, make a fist, and reach forward as far as possible without moving their feet while a measurement is taken. Lower scores on the test correlate with greater risk of falls.

Uploaded by

otmom18
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
639 views

Functional

The Functional Reach Test is a single-item test used to screen older adults for balance problems and fall risk. A score of 6 inches or less indicates a high risk of falls, while a score between 6-10 inches indicates a moderate risk. The test involves having a patient stand next to a wall with a yardstick, make a fist, and reach forward as far as possible without moving their feet while a measurement is taken. Lower scores on the test correlate with greater risk of falls.

Uploaded by

otmom18
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Functional Reach Test

The Functional Reach Test is a single item test


developed as a quick screen for balance
problems in older adults.
Interpretation:
A score of 6 or less indicates a significant increased
risk for falls.
A score between 6-10 inches indicates a moderate
risk for falls.

Age related norms for the functional reach test:


Men Women
Age (in inches) (in inches)
20-40yrs 16.7 ± 1.9 14.6 ± 2.2
41-69yrs 14.9 ± 2.2 13.8 ± 2.2
70-87 13.2 ± 1.6 10.5 ± 3.5
Requirements:
The patient must be able to stand independently for at least 30 seconds without
support, and be able to flex the shoulder to at least 90 degrees.
Equipment and Set up:
A yard stick is attached to a wall at about shoulder height. The patient is positioned in
front of this so that upon flexing the shoulder to 90 degrees, an initial reading on the
yard stick can be taken. The examiner takes a position 5-10 feet away from the patient,
viewing the patient from the side.
Instructions:
Position the patient close to the wall so that they may reach forward along the length of
the yardstick. The patient is instructed stand with feet shoulder distance apart then
make a fist and raise the arm up so that it's parallel to the floor. At this time the
examiner takes an initial reading on the yard stick, usually spotting the knuckle of the
third metacarpal. The patient is instructed to reach forward along the yardstick without
moving the feet. Any reaching strategy is allowed but the hand should remain in a fist.
The therapist takes a reading on the yardstick of the farthest reach attained by the
patient without taking a step. The initial reading is subtracted from the final to obtain the
functional reach score.
References:
Duncan, PW, Weiner DK, Chadler J, Studenske S. Functional reach: A new clinical measure of balance. J Gerontol. 1990;
45:M192.
Duncan, PW, et al: Functional reach: Predictive validity in a sample of elderly male veterans. J Gerontol. 1992; 47:M93.
Mann, GC, et al: Functional reach and single leg stance in patients with peripheral vestibular disorders. J Vestib Res. 1996; 6:343.
Weiner, DK, et al: Does functional reach improve with rehabilitation. Arch Phys Med Rehab. 1993; 74:796.

This and other balance tests can be found at AROM.COM ~ the web address for physical therapy
www.arom.com

You might also like