Scribd
Upload
2K views65 pages

ALINCO dr150

Uploaded by

Andy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
2K views65 pages

ALINCO dr150

Uploaded by

Andy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 65
ALINCO @ VHF“FM MOBILE TRANSCEIVER DR-150 = Instruction Manual Thank you for buying this ALINCO transceiver. This instruction manual contains important safety and operating instructions. Please read it carefully before using the transceiver. Table of Contents — @ Before Operating the semi) Accessories Installation Specification Q Comomsvin >) 1. Front panel. 2. Display .. 3. Rear panel 4, Microphone @ (‘Basic Operation ) 1, Receiving.. 2. Transmitting. 3 Operating modes See 4, Main and sub band operation 16 @ Advanced Functions 1. Memory channels Caling up a memory channel 7 ‘Temporarily changing a memory channel frequency (temporary mode). Programming a memory channel 8 Clearing a memorylrectaiming a memory... 19 ‘Transferring a memory to VFO 20 Operating in memory channel indication mods 2 2. Call channel é Calling up a call channel Changin the call channel's frequency 3. Channel scope VFO channel scope .... Memory channel scope. Channel scope operation with the DTMF equipped microphone (EMS-12) . 4, Scans... Seting a scan ‘ype. Band scan Programmed scan .... Memory scan . 5, Sweep scan Band sweep scan Programmed sweep scan Memory sweep scan 6 Priority watch... Priority watch while waiting on 2 channels. 7. Other functions... ‘S-meter squelch function. Setting the squelch timer, Shift and split settings (using different frequencies for transmit and receive)... Revere (ranemit and receive frequencies ‘are exCHANGEd) on. Setting the tone encoder . Changing tuning steps Key lock... Bell function ONIOFF...... ‘Adjusting the display brightness .. Beep tones ON/OFF Setting the transmit time-out timer... RF attenuator ON/OFF . Sending a tone burst signal 4 Changing the CALL/TONE key function ....... 41 Receive LITZ signal (OR-150T only) ‘AM receiving RRB SS8S888R8 B SBR RESSSRBRVBeR & Cloning, - 9. Resetting the CPU Full reset VFO reset Memory reset . Oana) General 1. Tone squelch... Tone scan 2.080 Setting DSQ mode. Programming DSQ codes Setting DSQ mode with a DTMF exupred microphone . Programming DSO codes with a DTMF ‘equipped microphone Communicating in code squelch mode ....... 51 Communicating in group pager Mode... 52 Communicating in private pager mode ....... 53 Changing the rate of transmission of DIMF codes... ‘Adjusting the DTMF code burst time ..... Transmitting DTMF codes manually 3 Auto-dialing Programming transmit codes into memory .... 55 Correcting a code that you have entered Confirming a received DTMF code ‘Transmitting a code using auto-dialing Inhibiting auto-dialing (clearing DIAL). © Remote control operation Operating procedure for microphone remote control : RERSS 5 a7 48 48 49 Entering a frequency. recy 60 ® (‘Packet operation ) General 1.1200 bps packet operation. 62 2, 9600 bps packet operation... soseneees 6B @ Cevenner _) . ° CS CE CS Cs ES Ce CC

You might also like